Experimental Study of Adhesive Wear of a Holding Device Using a Cross Cylinders Tester
Journal Title: Tribology in Industry - Year 2015, Vol 37, Issue 3
Abstract
Adhesive wear was identified in a cylinder of a rotating holding device of a forming die system, which permits to hold and align a leaf spring to carry out a punching operation at the automotive industry. To investigate the causes of the wear observed, an experimental study using AISI 5160 H and AISI 9840 R steels was carried out in a cross cylinder tester. The steel materials simulated the leaf spring and the cylinder of the holding device respectively. Like a remedy to reduce the adhesive wear, thermal chemical diffusion nitriding hardening was applied on the AISI 9840 R material and tested against AISI 5160 H in dry and lubricated conditions. The results showed that applying nitriding, the wear rate reduced around 97 % in dry conditions compared to the untreated steel. In lubricated conditions the wear for treated and untreated reduced by 98 %.
Authors and Affiliations
M. Vite-Torres , E. A. Gallardo-Hernández , E. Cruz-Ovando
Keywords
Related Articles
- EP ID EP111659
- DOI -
- Views 155
- Downloads 0
Static Coefficient of Rolling Friction at High Contact Temperatures and Various Contact Pressure
The paper theoretically and experimentally analyzes the influence of increased temperature and load contact in the value of the coefficient of rolling friction. Theoretical analyzes show that at temperatures of the order...
The Influence of the Relative Sliding on the Surface Quality
This paper presents a study on the surface quality pointing out the influence of relative sliding on the topography parameters. Traditional roughness parameters as Ra and Rq, deal only with relative high of the asperitie...
Frictional Response of Lubricant in EHL Contact under Transient Bi-directional Shear Loading
Consideration of performance, efficiency and energy consumption is nowadays an inherent part of the design of every modern machine. These factors are mainly determined by mechanisms taking place within the lubricated con...
Comparison of PID and Fuzzy PID Controller for a Linearised Magnetic Bearing
This paper is a presentation of a linear model of a magnetic bearing and a comparison of two controllers concerning their control performance. Initially, the benefits obtained by the use of magnetic bearings in the elect...
Potential of Using Recycled Low-Density Polyethylene in Wood Composites Board
The aim of this study was to investigate the suitability of using recycled low density polyethylene (RLDPE) in wood board manufacturing. The composite board was produced by compressive moulding by increasing the percenta...