Exploring the accuracy of lengths constructions when solving the engineering geodesy issues with RTN method
Journal Title: Геодезія, картографія і аерофотознімання - Year 2017, Vol 85, Issue 1
Abstract
Purpose: This study assumed: experimental determination of the accuracy of measuring relatively short distances, typical for performing survey, planning and marking engineering geodesy works using a dual frequency GNSS receiver under different conditions of observation, and using RTN-technology on mountain area of the Precarpathian region. Methodology: To investigate the accuracy of measuring short distances, seven experiments that differed in mutual position of permanent stations and physical geographical conditions of outside conditions were performed. To minimize the sporadic errors and increase the accuracy of obtained results, the investigation in the city of Ivano-Frankivsk was made on the inherent basis, which allows the forced centering of tools. The special aspect of this basis is that it is situated very close to the permanent station (10 km). Observations were made in RTN-mode with the receiver accepting differential alterations from the System Solutions network. Results: Results of the study are: obtainment of range accuracy depending on mutual positions of System NET network points; based on testing of the hypothesis about equality of general dispersions of two normally distributed groups, that are receiving an optimum quantity of necessary measurements when building lines areless than 200 m long. Scientific novelty and practical significance: It was defined, that the accuracy of building vector’s designation with a GNSS receiver under different conditions of observations is always higher than the accuracy of coordinate’s designation with the same device; the methodology of bases exploration under different conditions of observation was developed; the optimum quality of necessary measurements on the station in order to provide the given accuracy of results was established; the average square error of line length measurement, which depended on geometry of their location permanent stations.
Authors and Affiliations
K. Burak, B. Lysko
Method of measuring of exemplary basis of second category for verification of electronic total stations
Linear-angular intervals method of determining a exemplar basis for category 2 for verification of electronic total stations is proposed in the article. Experimental measurements on exemplary second level the basis were...
Comparison of the wet component of zenith tropospheric delay derived from GNSS observations with corresponding value from radio soundings
The purpose of this paper is to evaluate an accuracy of the wet component of zenith tropospheric delay obtained by the data of six GNSS stations in comparison with radio sounding data. The determination of hydrostatic an...
Absolute sea level changes at the tide gauge station in Władysławowo using different time series software packages
This paper presents geocentric sea level changes at the tide gauge station in Władysławowo, Poland. These changes have been calculated from the time series of GNSS and tide gauge observations. For the estimation of the g...
Cartographic providing of the administration of land resources
Purpose. Administration of land resources is an important component of the land state policy. In its turn, making informed decisions regarding the objective usage of the land resources, their protection and reproduction...
Analysis of modern methods surveying in the processing large-scale plans
Aim. Analysis modern methods surveying of processing large-scale plans. Method. Creating large-scale plans is an important task in mapping Ukraine because the existing topographic plans eventually need to be updated beca...