Failure Mechanism of Joints Between New Type Concrete-filled Steel Tubular with Special-shaped Columns and Steel Beams
Journal Title: 河南科技大学学报（自然科学版） - Year 2016, Vol 37, Issue 1
Abstract
According to the experimental research of the concrete-filled steel tubular special-shaped joints with interior diaphragm,the failure process and the load-steel web strain hysteretic curves were analyzed,and the failure modes of joints were obtained. The comparative analysis shows that the damage type of the panel zone is affected by the axial compression ratio,the ratio of the height to thickness of section of column and flange-pier wall of the joints. Based on the analysis of the failure modes of the joints and the influence factors,the failure mechanism was established. Restraint length provided by steel tube for concrete in flange-pier wall and webpier wall of joint was proposed based on the conditions of deformation coordination of the joints and the principle of virtual work.
Authors and Affiliations
Xi CHEN, Bin LIANG, Xiaomin LIU
Keywords
Related Articles
- EP ID EP460008
- DOI 10.15926/j.cnki.issn1672-6871.2016.01.012
- Views 101
- Downloads 0
Uncertainty Evaluation of Coordinate Measuring Machine for Diameter Measurement Based on Monte Carlo Method
The complete measurement results were composed of measurement estimation and measurement uncertainty,but coordinate measuring machine( CMM) only provided an estimated value of the measured parameters in the practical app...
Multi-fingered Dexterous Humanoid Mechanical Hand Driven by Pneumatic Fan-shaped Flexible Joints
Based on the bionics theory, a kind of pneumatic driven fan-shaped flexible joint was presented to meet the high demand of service robot for flexibility and safety of man-machine interaction, which was used in the constr...
Effect of Rib Stiffness on Stability of Ring-stiffened Functionally Graded Cylindrical Shells with Rib Eccentricity
Based on the Donnell thin shells theory, considering the influence of rib eccentricity, the stability equation of ring-stiffened functionally graded cylindrical shells under hydrostatic pressure was derived by using ener...
Microstructure and Properties of Electrodeposited Coatings on Titanium Surface
WC coating and CoCr/WC coating were prepared on the surface of TA2 basis material by electro spark deposition. The morphology, surface roughness, thickness, phase composition, microhardness and relative wear resistance o...
Experiment on Developing Technology with Plastic Tube Cast-in-place Concrete Pile in Construction
Plastic tube cast-in-place concrete pile( TC pile) had obvious reaming effect and pre-bearing capacity shortage in the construction. In view of this issue,developing new technology test for TC pile was carried out. This...