Field Evaluation of Cereal Combine Harvesters Processing Losses on JD-955 and JD-1165 Combines Equipped with Grain Loss Monitor
Journal Title: Journal of Agricultural Machinery - Year 2014, Vol 4, Issue 2
Abstract
Grain loss monitors are installed on combine harvester and make it possible to measure grain loss on different parts of the combine. The instrument permits the operator to adjust a proper ground speed to keep grain loss within an acceptable range. In this study a loss monitoring system was implemented to measure grain losses continuously on straw walker and sieves. Two grain loss monitors (KEE and TeeJet) were installed behind the straw walker and the sieves of JD-955 and JD-1165 combine harvesters. Harvesting performance parameters such as combine total and processing losses were then measured. To evaluate the precision and accuracy of the instruments, the measured and monitored losses were compared and investigated. The results of a two-year research showed that the average processing loss of the combine harvesters with 10-12% grain moisture content and 750 rpm drum speed was 0.82% which is whitin the acceptable range recommended by ASAE Standard No. S343.3. Furthermore, there was no significant difference between the measured and monitored values of processing loss.
Authors and Affiliations
M. R. Mostofi Sarkari,M. S. Valiahdi,I. Ranjbar,
Keywords
Related Articles
- EP ID EP717734
- DOI -
- Views 52
- Downloads 0
Development of an Electronic System for Determining Vertical Loads on the Rear Axle of Cereal Combine Harvesters in Motion
Introduction The cereal combine harvester is one of the agricultural machines that works in difficult conditions and its parts are constantly under various static and dynamic loads. For the optimal design of vehicle part...
Prediction the inside variables of even-span glass greenhouse with special structure by artificial neural network (MLP-RBF) models
IntroductionControlling greenhouse microclimate not only influences the growth of plants, but is also critical in the spread of diseases inside the greenhouse. The microclimate parameters are inside air, roof, crop and s...
Qualitative and quantitative analysis of biogas generated from co-digestion of cow dung, municipal sewage and kitchen waste
Introduction As reported by Sabetghadam (2005), 53.4, 36.3, 1.1, 8.9, and 0.2% of total energy consumption in Iran consisted of oil products, natural gas, coal, electricity energy, and modern energy sources, respectively...
Design and Evaluation of Two New Biomimetic Blades for Reducing the Shear Energy Required for Cutting Herbal Plants
Introduction Optimizing the energy consumption in mechanized agriculture is becoming more important due to the limited energy sources in the world. In this regard, optimization of the cutting blades is presented in this...
Investigating The Long-term Effect of Preventive Maintenance Strategy on The Operational Efficiency and Failure Rate of Sugarcane Harvester Using Time Series
Introduction Optimal operation and maintenance of engineering systems heavily relies on the accurate prediction of their failures. Repairable engineering systems are well known in industries. A repairable engineering sys...