Flexural Performance Numerical Model Analysis of Transverse Welded Joints in Prefabricated Diaphragm Walls
Journal Title: Urban Mass Transit - Year 2024, Vol 27, Issue 12
Abstract
［Objective］ The transverse joints within the panels of prefabricated diaphragm walls are the weak points in the entire wall structure. Therefore, it is necessary to study the stiffness and strength characteristics of these joints. ［Method］ In conjunction with prefabricated diaphragm walls commonly used in foundation pit engineering, a new type of transverse welded joints for prefabricated diaphragm walls is introduced. The force and deformation behavior of this new joint under bending moment actions are studied using numerical simulation methods. ［Result & Conclusion］ Under bending moment actions, the tensile stress in the concrete at the end of the angle steel on joint tensile side is the highest, while the compressive stress in the concrete at this position on joint compressive side is the highest. The failure of the joint begins with cracks of the concrete on tensile side. The deflection curve of the component shows no significant mutation at the joint, indicating good deformation performance of the joint, which effectively prevents water leakage. The stress in the angle steel, weld, and rebar on joint tensile side is greater than that on the compressive side. After cracks appear in the concrete on the tensile side, the stress in the angle steel, weld, and rebar of the prefabricated component remains at a low level.
Authors and Affiliations
Tao CUI
Keywords
Related Articles
- EP ID EP752730
- DOI 10.16037/j.1007-869x.2024.12.025
- Views 20
- Downloads 0
Simulation Analysis of A Metro Station Construction in Shenzhen with Small TBM Advancing Excavation Followed by Large TBM Enlargement
[Objective] The new technique of small-diameter TBM (tunnel boring machine) advancing excavations followed by large-diameter TBM enlargement is used for the first time in the construction of Tumor Hospital Station on She...
Predicting Method for Lining External Water Pressure Reduction Coefficient Based on Equivalent Stable Drainage Volume Principle
［Objective］ By establishing a numerical seepage analysis model that aligns with real drainage systems and introducing the concept of a ′virtual permeability coefficient′ for secondary lining, the objective is to delve...
Development and Application of Mechanical Shield Tail Clearance Measurement Device Based on Angle Sensor
Objective In view of the constant changes of shield tail clearance during shield or tunnel boring machine excavation process, to ensure construction safety, it is necessary to measure shield tail clearance in real-time....
Simulation Analysis of Factors Influencing Vehicle Passing Performance through Large-slope Metro Turnouts
Objective In the actual metro construction, it is often necessary to lay turnouts on large-slope sections due to planning and construction constraints, land conservation or topographical limitations. However, it is found...
Theoretical Study on the Relationship between Stiffness and Modal of Railway Passenger Car Bodies
［Objective］ To analyze the relationship between carbody stiffness and modal, and to provide theoretical support for the modal analysis of lightweight carbodies, it is necessary to conduct a theoretical study on both as...