FORMATION OF WEAR-RESISTANT GASOTERMIC COATINGS ON TITANIUM ALLOYS
Journal Title: Проблеми тертя та зношування - Year 2018, Vol 81, Issue
Abstract
The patterns of formation of detonating plasma coatings are investigated. Chemical and phase X-ray-structural analysis of powder and coatings after spraying are performed. The study results of the obtained coatings wear resistance are presented. It is established that the coating structure after spraying consists of carbides particles distributed in the metal matrix, as well as oxide of the weeping elements. The microstructure is heterogeneous in terms of the components structure, their microhardness and distribution. The microhardness of the particles varies depending on the type of the curing metal and the size of the carbides. If the output particles are 80-100 μm, the carbide impregnation has a microhardness of 14-29 GPa. With a decrease in the magnitude of the source particles there is a more complete interaction with the material in the process of spraying. Microhardness of carbides at the same time decreases. The sizes of carbide particles in the plasma coating of titanium carbide, covered with nickel and copper, are 20-60 μm. In the structure there are separate conglomerates of particles that are formed obviously at the stage of the powder coating. The structure of detonation coatings is characterized by a more even distribution of particles in the matrix, their microhardness does not exceed 12 GPa, the size - no more than 10 - 15 microns. According to the abovementioned studies, it has been established that titanium alloys have low antifriction properties: high and unstable friction coefficient and are disposed to solidification. The main way of increasing the efficiency of titanium alloys in the nodes of friction - the application of coatings on parts of these alloys. The most promising coatings that are applied by various spraying methods, due to technological capabilities, technical and economic indicators, that have significant ad-vantages over traditional coating methods.
Authors and Affiliations
N. M. STEBELETSKA, S. V. FEDORCHUK, Yu. O. TSUBRII
Keywords
Related Articles
- EP ID EP437806
- DOI -
- Views 41
- Downloads 0
THE CONCEPTUAL APPROACH TO THE CREATION OF THE SURFACE-MODIFIED LAYERS AND PROTECTIVE COATINGS OF THE INCREASED WEAR RESISTANCE
Based on the energy model of the tribosystem and the ideas about the structure- rheological mechanisms of energy dissipation and the reduction of the tension of the surface layers in a dynamically loaded frictional conta...
THE INFLUENCE OF ROLLING MODES DURING DEFORMATION-DIFFUSION TREATMENT ON WEAR RESISTANCE OF ВТ22 TITANIUM
The influence of rolling modes during deformation-diffusion treatment on wear resistance of ВТ22 titanium was investigation. Deformation-diffusion treatment includes previous cold surface plastic deformation (CSPD) and f...
CONCENTRATIONS FORMULA CONDITIONAL OPTIMALITY WITH RESPECT TO THEIR ENTROPY
The paper theoretically considers the possibility of the multi-optional hybrid func- tions entropy conditional optimization doctrine applicability with the purpose of dis- covering substantiated reason for the mean conce...
INVESTIGATION OF THE MECHANISM OF BORIDE COATING WEAR UNDER CONDITIONS OF BOUNDARY FRICTION
Carry out investigation mechanism wear-and-tear twophase of one-phase coating of low-carbon steel 45 of condition friction of boundary lubrication. At introduction part scientific article of give an example of actuality...
THE QUESTION OF THE USE OF DYNAMIC MODELS OF DISC BRAKES OF VEHICLES IN ACTUATORS OF HOIST-TRANSPORT MACHINES
A feature of modern lifting machines is the continuous improvement of their operational pa-rameters, such as payload, speed and depth of the lift, reducing the material consumption of equipment due to increased efficienc...