Friction in Orthogonal Cutting Finite Elements Models with Large Negative Rake Angle
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 2
Abstract
In this paper, orthogonal cutting finite elements models are built for the investigation of the impact of large negative rake angles on the friction coefficient in the tool-chip interface in machining. The simulation results give an insight on the mechanism of chip formation in processes with large negative active rake angle, such as machining with chamfered tools, grinding and micromachining. For the present analysis, cutting conditions resembling the qualitative and quantitative characteristics of the aforementioned processes were selected. More specifically, tool rake angles varying from -10o to -55o and Coulomb friction with constant friction coefficient were considered. The results indicate that friction coefficient is greatly affected by the negative tool rake angle, exhibiting values well above 1 for the high extreme of the examined rake angle spectrum.
Authors and Affiliations
A. P. Markopoulos , N. E. Karkalos , N. M. Vaxevanidis , D. E. Manolakos
Keywords
Related Articles
- EP ID EP123222
- DOI -
- Views 83
- Downloads 0
Effect of TiO2 Nanoparticles Blended with Lubricating Oil on the Tribological Performance of the Journal Bearing
This paper presents the performance analysis for plain and elliptical journal bearing operating with industrial lubricants. Titanium dioxide nanoparticle of size 40 nm is used as a lubricant additive to examine the perfo...
Flammability Tests on Hot Surface for Several Hydraulic Fluids
Industrial equipment using hydraulic fluids are design to accept higher load and speed, implicitly higher temperatures, including for fluids. Leakages from enclosures like gear boxes or hydraulic systems could increase t...
The Tribological Investigations of Multicomponent Multilayered Ion-Plasma Coatings Avinit
The friction and wear characteristics of sliding friction in conditions of boundary lubrication for coatings, received by ion-plasma method on the heat resistant deformed alloy of АК4-1 type are investigated. Conducted t...
Wear Properties of A356/10SiC/1Gr Hybrid Composites in Lubricated Sliding Conditions
This paper presents basic tribological properties of A356/10SiC/1Gr hybrid composites in conditions with lubrication. Hybrid composite specimen is obtained by compocasting procedure. A356 aluminium alloy is used as a bas...
Theoretical Investigation of Transient Ultra-Thin Lubricant Film During Rapid Deceleration
A theoretical model using Newton-Raphson technique to study the behavior of ultra-thin film thickness formation subjected to transient speed conditions is presented in this paper. The transient oil film pressure and oil...