Heat resistance of Fe-Al intermetallics in the context of selected heat-resistant and hihg-temperature creep resistant steels
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 2
Abstract
Results are hereby presented of heat-resistance tests of two Fe3Al and FeAl intermetallic phase-based alloys in the context of St41k-type boiler steel and 50H21G9N4 high-temperature creep resistant steel. It has been ascertained that heat resistance of the 50H21G9N4 steel and of the Fe3Al and FeAl intermetallic phase-based alloys significantly exceeds that of the boiler steel tested in the air atmosphere and the atmosphere of a flue gas with CO, CO2, SiO2 content alike. Improvement of these properties depends of exposure conditions. The largest differences have been observed when the tests were carried out in temperature 1023 K and in the flue gas atmosphere. The differences have been more and more noticeable as the exposition duration extended. A tendency has been also recorded of smaller mass decrements of the Fe3Al and FeAl intermetallic phase-based alloys as compared to the 50H21G9N4 steel.
Authors and Affiliations
A. Patejuk, M. Gawrylewski, P. Baranowski
Keywords
Related Articles
- EP ID EP70539
- DOI -
- Views 96
- Downloads 0
Effect of pouring temperature on the Lost Foam Process
In this study, the analysis of the influence of the pouring temperature on manufacture process of castings by the Lost Foam method was introduced. In particular, numerical simulation results of effect of silumin and grey...
Macrostructure of IN-713C superalloy after volume modification
The study discusses the results of the preliminary investigations of the process of volume modification of nickel and cobalt superalloys. The investigations were carried out on an IN-713C alloy. As an inoculant, cobalt a...
Usage of Connor Inlets to Eliminate Shrinkage
The demand for castings of high quality and sound work is nowadays very high. The production of sound castings without foundry errors is the big issue in modern foundries. Foundry simulation software can do a lot to help...
The influence of modification and squeeze casting on properties of AlSi11 alloy castings
The results of structural examinations and tests of mechanical properties of AlSi11 alloy, either gravity or squeeze cast, have been presented. The investigations have been carried out for both the non-modified silumin a...
The effect of the production process of medium-carbon steel on fatigue strength
The experimental material comprised semi-finished, high grade, medium-carbon structural steel for the production of mining chains. Steel was melted in a 140 ton electric furnace and desulfurized (E). In the second analyz...