High Speed Low Power Self Timed CAM Application Based On Reordered Overlapped Search Method
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 4
Abstract
This paper introduces a reordered overlapped search mechanism for high-throughput low-energy contentaddressable memories (CAMs). Most mismatches can be found by searching a few bits of a search word. To lower power dissipation, a word circuit is often divided into two sections that are sequentially searched or even pipelined. Because of this process, most of match lines in the second section are unused. Since searching the last few bits is very fast compared to searching the rest of the bits, we propose to increase throughput by asynchronously initiating second-stage searches on the unused match lines as soon as a first-stage search is complete. This allows the circuits to be in the required phase for their own local operation: evaluate or precharge, instead of having to synchronize their phase to the rest of the word circuits, which greatly reduces the cycle time. The proposed asynchronous CAM operates faster than a synchronous CAM with smaller energy dissipation. An internet protocol (IP) filter is used to unblock particular applications which determine the next hop for a packet by finding the longest prefix match. This lookup often occurs in content addressable memory (CAM), which allows bit masking of the IP address.
Authors and Affiliations
P. Uma Devi, Mr. P. Sukumar
Keywords
Related Articles
- EP ID EP20144
- DOI -
- Views 257
- Downloads 4
1-Φ High Step-Up Converter with MB MPPT for Half-Bridge PV Inverter System
In this paper a 1-ϕ high step-up converter with model based mppt for half-bridge inverters is proposed. The high stepup converter not only boosts the relatively low photovoltaic voltage to high bus voltage but also offer...
IOT Based Smart Environmental Monitoring Using Arduino
This paper proposes an approach to build a cost effective standardized environmental monitoring device using the Arduino Board. The system was designed using Embedded C Programming language and can be controlled and acc...
Control Of Vehicle Pollution Through Internet Of Things (IOT)
Emissions that are released directly into the atmosphere from the tailpipes of vehicles are the primary source of vehicular pollution. With the increase in urbanization and industrialization and due to poor control on e...
An Implementation of Fault Node Replacement algorithm for Wireless Sensor Network
In Wireless Sensor Network every Sensor node having a tendency to shut down ,due to computation power, Hardware Fail, Software Fail, environmental Condition and energy depletion. Fault Tolerance is a major problem in a...
Multipath Routing Using Neuro Fuzzy in Wireless Sensor Network
In this project, neuro fuzzy mulipath routing protocol around connectivity holes is developed. The neuro fuzzy multipath routing protocol is mainly used as a apparatus to sense and route around connectivity shacks. The...