Improvement of performance of finishing of details with a cutting tool
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2017, Vol 80, Issue 2
Abstract
The possibilities of increasing the productivity of finishing blade processing due to the control of cutting modes are analyzed. Prospective approaches to increasing the feed and cutting speed on examples of an oblique cutter, tools equipped with polycrystalline superhard composites based on cubic boron nitride, tools with protective coatings are considered. The use of tools developed taking into account the features of the phenomena occurring in the cutting zone, the use of cutting tools with special protective coatings provides the possibility of performing finishing blades with high productivity.
Authors and Affiliations
S. A. Klimenko
Keywords
Related Articles
- EP ID EP256868
- DOI -
- Views 100
- Downloads 0
Connection between surface microrelief of friction pairs and intensity of their attrition in non-stationary exploitation conditions
Comparing with the previous publications related to surface microrelief of friction pairs, this article focuses on investigation of workpiece surface interaction having different or similar, fully or partially regular sl...
Digital signals processing using non-linear orthogonal transformation in frequency domain
The rapid progress of computer technology in recent decades led to a wide introduction of methods of digital information processing practically in all fields of scientific research. In this case, among various applicatio...
Determining the optimal loads on mechanism nodes using digital technology prototype
This article gives us important details about applying of a digital prototype for the purposes of reduction drive assembly testing. Working with digital prototype helps every user to make detailed virtual research, to es...
Development of effective system parameters of borehole charges for the destruction of the mountain massif at the packing level
So far, little attention has been paid to the horizontal free surface of the ledge, or rock layer, which is located within the packing. However, this part of the block, which must also be effectively destroyed, in the va...
Analysis of the influence of the distribution of mined rock transportation on the sum of transport operation
The purpose of this work is to further develop a methodological basis for determining the coordinates of the optimal mining point for mines and to study the impact on the optimal transportation location of the spatial lo...