Increasing Production Rate of Gear Box Assembly Using SMED Concept
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 4
Abstract
In This Paper The Purpose Of The Single Minute Exchange Die (SMED) Is To Eliminate Waste Of Time. Longer Setting Up Time Denotes That Production Line Is Not Very Productive. Nowadays, Everything Is Being Done Faster And JustIn-Time, Where Manufactures Need To Produce Product Fast And Without Neglecting The Quality And Deliver It To Customer In Right Time. In This Project, SMED Has Been Provided To Eliminate Waste Of Time (Lead Time) With Eight Technique Of SMED. In SMED, Molds Or Die Exchange Should Be Less Than 10 Minute And It Helps In Improvement Of Gear Box Assembly. The SMED Methodology Is Applied To Reduce The Setup Times Observed At The Beginning Of The Project. It Was Possible To Reduce Setup Times, Work-In-Process And Distances Walked By Operators With Developed Solutions. Also The Lead Time Of The Process Is Also Considerably Reduced. Further, The Setup Operations Were Standardized And As A Result The Process Has Become More Fast And Productive For The Workers. In This Project The Fixtures, Clamps And Holder Were Designed Using Creo Software.
Authors and Affiliations
Selvakumar. S, Saravanakumar. K, Shreenivasan. S. N, Sathyanarayanan. V, Asst. Prof D. Sarath Kumar
Keywords
Related Articles
- EP ID EP23800
- DOI http://doi.org/10.22214/ijraset.2017.4093
- Views 246
- Downloads 8
Implementation of an Enhanced Wilkinson’s Power Divider using Low Pass Filters
A novel design of power divider using pi-filter is proposed in this paper which suppresses the harmonics in the circuit. There are several advantages of using this design. The simplicity of the circuit is enhanced as th...
Low Cost Multiple Output Concentrated Solar Energy System (CSES)
Low cost multiple output concentrated solar energy system is centred towards the maximum utilization of solar energy, both direct and diffused radiations producing output as a combination of Electricity, Hot water and s...
Investigation on the micro structural and surface morphological properties of SILAR grown CdO thin films by altering dipping cycle
Cadmium oxide (CdO) thin films were prepared by successive ionic layer adsorption and reaction (SILAR) method by altering dipping cycle. The prepared films were annealed at 2500C for 2 h. The prepared films were charact...
Wireless Military Bomb Disposal Robot
Nowadays bomb disposal and diffusing has become a very critical and hazardous method to human’s life, In order to overcome from this we are going to introduce a concept based on wireless bomb disposal robot. In this the...
Mathematical Modeling and Simulation of Switched Reluctance Motor
The SRM motors are simple in construction structure. The switched reluctance motor has high torque, high reliability and inexpensive manufacturing cost. This paper describes the mathematical model of SRM motor and its w...