INFLUENCE OF HEIGHT OF ARTIFICIAL ROUGHNESS ELEMENTS ON FLOW IN DIFFUSER CHANNEL
Journal Title: Проблеми тертя та зношування - Year 2017, Vol 76, Issue
Abstract
In the work a series of calculations of flow in diffusers at an opening angle 20°...32° was carried out. With an increase in the opening angle in smooth diffusers the flow separation with the several vortices is observed. The paper presents the results of the study on the effect of the change in the height of the elements of artificial roughness on the losses level in the diffuser channel. The elements of artificial roughness were located in the entrance area of the diffuser. The height of the roughness elements varied from 0.5 mm to 0.2 mm. The results of the research have shown that the installation of artificial roughness influences the flow parameters in the diffuser channel. The use of elements of artificial roughness, the height of which gradually increases, leads to a decrease in the level of hydraulic losses in the diffuser channel.
Authors and Affiliations
YU. YU. TERESHCHENKO
Keywords
Related Articles
- EP ID EP366351
- DOI -
- Views 128
- Downloads 0
EXPERIMENTAL INVESTIGATION OF THE PROPERTIES OF GEOMODIFIERS IN FRICTION PAIRS
The paper presents the results of research on friction surfaces microprocessing using geomodi-fiers (GMF). Studies have been done on the content of GMF in oil in percent, which provides the required anti-friction propert...
RESOURCE INDICATORS MANAGEMENT OF MODERN TECHNICS STRUCTURAL ELEMENTS THROUGH THE APPLICATION OF ENERGYSAVING TECHNOLOGIES OF SURFACE MODIFICATION
The paper studied the microhardness, structure, phase composition and durability of structural elements of modern technics (for example, steel 20X13) strengthened by a pulsed gasthermocyclic ionic nitriding. In strengthe...
PROFESSOR A. KUDRIN CREATIVE CAREER
PROFESSOR A. KUDRIN CREATIVE CAREER
INVESTIGATION OF TRIBOTECHNICAL CHARACTERISTICS OF ELECTRIC ARC IRON-COPPER COATINGS WITH PSEUDO-ALLOY STRUCTURE
Investigations of tribotechnical characteristics of electric arc pseudoalloy iron-copper coatings under con- ditions of dry sliding friction were performed. Volumetric wear and friction coefficient were determined. A met...
TRIBOTECHNICAL INVESTIGATIONS OF HIGH-TEMPERATURE SENSORY MATRIX-SUPPLIED ALLOYS
The questions of creation of high-temperature wear-resistant alloys for increase of wear resistance of parts of the hot part of gas turbine engines by the method of isostatic hot pressing are considered. The alloys of th...