Interlocking Nailing Versus Plating in Tibial Shaft Fractures in Adults: A Comparative Study
Journal Title: Journal of Clinical and Diagnostic Research - Year 2017, Vol 11, Issue 4
Abstract
Introduction: Tibial diaphyseal fractures are the commonest long bone fractures in adults, most commonly managed by intramedullary interlocking nailing. However, several metaanalysis show that locking plate osteosynthesis is equally effective in managing tibial diaphyseal fractures and are associated with less number of complications. Aim: To compare the results of fixation of tibial fractures following plating and nailing in terms of union, patient satisfaction and complications. Materials and Methods: A hospital based non randomized clinical trial was performed from September 2013 to August 2016 where closed or open diaphyseal or metaphyseo- diaphyseal fractures of the tibia (closed or open Gustilo Anderson type 1 through 3B) were included. Simple sequential allocation was used for allotting the patients to two groups, one for interlocking nailing and other for plating. The patients were followed up for clinical, radiographic and functional results. Results: Forty patients with 41 involved limbs completed follow up for one year. The duration of surgery and average blood loss during surgery was 75.45±3.03 minutes and 165.00±5.31 ml respectively in case of nailing and 85.05±2.54 minutes and184.29±5.33 ml respectively in case of plating and their difference was statistically significant. In our study union was achieved in less than 20 weeks in 29 (70.8%) of the patients and 25-30 weeks in nine (22%) cases. The average time of union in our study was 19.55±0.69 weeks in case of interlocking nailing and 20.38±1.39 weeks in case of plating and there was no statistically significant difference between the two. However, there is statistically significant difference in the functional score in between the two groups in terms of Lower Extremity Functional Score (LEFS). Delayed union in one case of nailing and two cases of plating, valgus malunion in one case of nailing and joint stiffness in two cases each of nailing and plating were the major complications observed. Conclusion: There was no difference between the two modalities in terms of fracture union. Complications were lesser but more serious in case of plating. Patient satisfaction was more with plating.
Authors and Affiliations
Sagnik Mukherjee, Mahendra Singh Arambam, Sanjib Waikho, Dr. Santosha, Pranav Vitthal Masatwar, Rohan Gautam Maske
Efficacy and Adverse Effects of Topical Latanoprost with Respect to Preservative in Patients of POAG
ABSTRACT Introduction: Primary open angle glaucoma (POAG) is the most common form of Glaucoma and elevated IOP is one of the leading risk factor. It is shown that reduction in IOP slows the disease progression. Prostagla...
Recall of Complications and Satisfaction of Consent in Mandibular Third Molar Surgery: A Randomised Controlled Single Blind Study
ABSTRACT Introduction: Informed consent prior to any medical procedure is important for legal, ethical and administrative reasons. Informed consent intends to improve the patients’ knowledge which will allow involvement...
Effect of Cellular Mobile Phone Use and Cetrizine on Hand-Eye Coordination and Visual Acuity
Introduction: Cellular mobile phones are a major cause of distraction especially while driving. The aggressive and inappropriate use of cellular mobile phones has increased the risk of accidents. Similar alerts are avail...
Arm Function and Quality of Life Among Patients after Mastectomy
ABSTRACT Introduction: For many women with breast cancer, mastectomy is a common form of treatment which has an indirect effect on female beauty, sexuality and feminity. Also, the patients suffer severe arm and shoulder...
Reciprocal Relations between Work and Health: A Theoretical Understanding from the History of Occupational Health and Behaviour
ABSTRACT A healthy workplace is always required for promotion of good health and wellbeing of workers. Health depends on reinforcement of various external factors of productivity. Performance of a worker is influenced by...