Internal Mechanical Power During Cycling Using Non-Circular Versus Circular Chainrings
Journal Title: Journal of Science and Cycling - Year 2015, Vol 4, Issue 2
Abstract
Introduction: Non-circular Rotor Q-Rings have been shown to increase tangential force during the pedalling downstroke compared to conventional circular chainrings1, and due to this advantage, have been proposed as a potential aid in improving short-term cycling performance such as in BMX and sprint cycling races2. Some evidence exists that suggests this effect on pedal force may manifest in a change in metabolic cost over repeated revolutions during submaximal, steady-state cycling bouts using Rotor Q-Rings3. One mechanism by which a change in total metabolic cost may occur is via a change in the power required to move the limbs segments against gravitational and inertial forces through the pedal stroke (internal mechanical power, or IP) when compared to using circular chainrings (at the same external mechanical power, EP). Strutzenberger et al.1 reported an increase in joint muscle power of the hip when Q-Rings were used compared to circular chainrings at 70 and 90 rev · min-1, which could cause an increased IP and result in a greater total metabolic cost. The aim of this study was to further investigate the mechanical and metabolic energetics of using Q-Rings during cycling. Their effect on IP, compared to a conventional circular chainring, was assessed using a recently-proposed, multidisciplinary model for calculating IP in cycling4, which accounts for the strengths and limitations of previous biomechanical and physiological approaches. Total metabolic cost was also compared between the two chainrings for cycling over a range of workloads. Method: Ten elite male road cyclists completed 5-min cycling bouts at 80 rev · min-1 at 100, 200 and 300 W using a standard circular chainring and 52-tooth Q-Ring set in two positions: ‘#1’ and ‘#5’. Oxygen consumption was converted to metabolic power. Tangential and radial crank forces and crank position were measured using Axis Cranks (SPE, Carole Park, Australia). The x-intercept of the EP-metabolic power relationship, multiplied by the slope (delta efficiency), was equal to the physiological estimate of IP. The biomechanical estimate of IP was taken as the summed muscle joint power, determined from digitised video footage and inverse dynamics analysis, in excess of that required to apply power to the pedals (Giorgi et al. 2014). Results: Preliminary analysis of data is presented in Table 1. Data are presented as mean ± SD. No significant differences were found between the chainrings for total metabolic power or the physiological estimate of IP. Discussion: Further analysis will allow the description of changes in potential and rotational kinetic energies and muscle and joint powers throughout the pedal revolution. This information will permit the calculation of the biomechanical estimate of IP and comparisons to be made between chainrings and Q-Ring positions.
Authors and Affiliations
Giorgi, H. | The University of Queensland, School of Human Movement Studies (Brisbane, Australia).Queensland Academy of Sport (Brisbane, Australia), Andrews, M. | Queensland Academy of Sport (Brisbane, Australia), Osborne, M. | The University of Queensland, School of Human Movement Studies (Brisbane, Australia).Queensland Academy of Sport (Brisbane, Australia)
Keywords
Related Articles
- EP ID EP2918
- DOI -
- Views 387
- Downloads 29
Potentiation of sprint cycling performance: the effects of a high-inertia ergometer warm-up
Background: Individual response to acute post-activation potentiation (PAP) stimulation is affected by factors such as the conditioning protocol design, training status, and biomechanical similarity of the conditioning a...
Amateur cyclists can complete the full Tour de France in the same amount of days as professional cyclists
Participating in the Tour de France (TdF), 3.497 kilometres in 21 days, is a challenge for professional as well as for amateur cyclists. The exceptional high demands both physically and mentally enhance the risk of falli...
Modelling of critical power from road data
Background: Performance tests are an integral part of evaluating competitive cyclists. Despite all technological and physiological advances, limited research has been performed addressing the translation of standardized,...
Power output and affective load change during time trial according to environmental conditions
Introduction: During cycling events, riders have to face to different environmental conditions like wind or road gradient, which leads to variable resistive forces. Those resistances involve a specific pedaling cadence (...
Analysis of gender policies of the Spanish cycling and triathlon federations from the point of view of representative athletes and expert technicians
The Spanish National Sports Council, through its program “Women and Sport” (published in the Decree Pre/525/2005), implements specific entities in Spanish cycling and triathlon federations with the aim of promoting the s...