INVESTIGATION OF HIGH-CURRENT INTERRUPTING CONTACTS WORKING SURFACES MECHANICAL INTERACTION NATURE
Journal Title: Електротехніка і Електромеханіка - Year 2016, Vol 0, Issue 1
Abstract
Introduction. The nature of the interaction of high-working surfaces of the electrical contact uniquely affects their performance. By the failure of the contacts in the main drive processes resulting from complex destructive factors affecting their performance. However, not all processes are studied in detail and give in modeling. The purpose of the paper is to show the possibility of using the method of holographic interferometry to estimate the plastic deformation in the zone of contact interaction. One of the significant factors affecting the work of the contact pair is the compressive force of the contact surfaces. Compression discontinuous contact is directly connected with the processes of elastic and plastic deformation of the contact material, which is particularly evident in the contact details of the powder or composite materials. The paper focuses on the plastic deformation of the surface layers of discontinuous contact in circuit, it is believed that it is directly related to the mechanism of conductivity of contacts. As shown, a significant effect on the deformation of the contact surfaces and renders the working environment, in particular transformer oil. Methodology. Assessing the impact of compression forces on the deformation of the contact surface was conducted experimentally using the method of holographic interferometry. Results. Experimental studies, which indicated that the compact and powder materials plastic deformation in and around the area microcontacts simplistically stated that requires experimental verification. A method for evaluating the state of stress, which affects the formation and destruction of the local contact spots. Practical value. Using the experimental method of determining the movement of the contact region allows you to optimize discontinuous contacts from composite and powder materials.
Authors and Affiliations
O. G. Volkova, L. B. Zhornyak
Keywords
Related Articles
- EP ID EP289153
- DOI 10.20998/2074-272X.2016.1.02
- Views 118
- Downloads 0
THREE-ELECTRODE AIR SWITCHBOARD WITH THE GRAPHITE ELECTRODES OF KATG-50 ON VOLTAGE TO ±50 KV AND IMPULSE CURRENT BY AMPLITUDE TO ±220 KA
Purpose. Development and creation of the simplified construction of a high-voltage heavy-current air three-electrode switchboard with graphite electrodes, intended for operation in composition the powerful generator of l...
NUMERICAL SIMULATION OF SPARK DISCHARGE CHARACTERISTICS IN LIQUID NITROGEN
In MHD approximation, a mathematical model of spark discharge in liquid nitrogen is worked out on the basis of data generalization pertaining to thermodynamical functions and mass-transfer coefficients in a wide paramete...
NEURO-SYSTEM OF AIMING AND STABILIZING WITH A REGULATOR ON THE BASIS OF STANDARD MODEL MODEL REFERENCE CONTROLLER
The aim of this work is the synthesis of neural network aiming and stabilization system for the special equipment of moving objects with neuro-controller on the basis of standard model and performance comparison of the n...
MATHEMATICAL MODEL OF ELECTROMAGNETIC PROCESSES IN LEHERA LINE AT OPEN-CIRCUIT OPERATION
Purpose. The work proposed for the modeling of transients in Lehera line uses a modified Hamilton-Ostrogradskiy principle. The above approach makes it possible to avoid the decomposition of a single dynamic system that a...
ON THE PROBLEM OF INCREASING COMPUTATION ACCURACY FOR RATED PARAMETERS OF ACTIVE ELECTRICAL INSTALLATION GROUND GRIDS
In the paper, factors having effect on computation accuracy of ground grid rated parameters are analyzed. Directions and techniques for increasing the rated parameter computation accuracy are suggested. The techniques co...