INVESTIGATION OF LOCAL AND MODAL BASED ACTIVE VIBRATION CONTROL STRATEGIES ON THE EXAMPLE OF AN ELASTIC SYSTEM
Journal Title: Journal of Machine Engineering - Year 2019, Vol 19, Issue 2
Abstract
Nowadays, feed axes are often equipped with multiple parallel-acting actuators in order to increase the dynamics of the machine tool. Also, additional actuators for active damping are widely used. Normally, the drives or actuators are controlled independently without consideration for the impact on each other. In contrast, by using the modal space control, the system can be decoupled and the modal control loops can be adjusted independently. This control approach is particularly suitable for motion systems, such as machine tools, which have more drives or actuators than degrees of freedom of movement. This paper deals with the pre-investigation of the modal-based vibration control for machine tools with additional actuators. The object of investigation is an elastic system with a movable saddle. The modal-based control is compared with a local control approach. The results obtained experimentally on the test rig are presented. The modal control is superior since, with the modal approach, each control loop corresponds to a specific vibration mode, and the control law for this loop is designed to provide the desired performance of the control system at the corresponding resonance frequency. The parameterisation of the control loops is simplified by modal control, since the modes can be controlled independently.<br/><br/>
Authors and Affiliations
Christoph PEUKERT, Patrick PÖHLMANN, Marcel MERX, Steffen IHLENFELDT, Jens MÜLLER
Keywords
Related Articles
- EP ID EP599575
- DOI 10.5604/01.3001.0013.2222
- Views 77
- Downloads 0
The comparative analysis of the selected construction types of axial compressor stage including the modal analysis
The article concerns the issues of the scope of optimization of the gas turbine jet engine. These issues include limiting the weight and number of engine parts. One way to reduce the weight and number of components, incl...
COMPARISON OF STATIC AND DYNAMIC LASER BASED POSITIONING METHODS FOR CHARACTERIZATION OF CNC MACHINES
In the paper we compare the laser based measurements of linear parameters of numerically controlled machines. A new dynamic method of measuring machine positioning is described and compared with the widely used static m...
ENERGY-BASED CHARACTERIZATION OF PRECISION HARD MACHINING USING PARTIALLY WORN CBN CUTTING TOOLS
This paper highlights the performance of precision hard turning with CBN cutting tools from energy point- of-view with additional tool wear effect. For this purpose several wear tests were performed during which the tool...
PARAMETERIZATION OF ENVIRONMENTAL INFLUENCES BY AUTOMATED CHARACTERISTIC DIAGRAMS FOR THE DECOUPLED FLUID AND STRUCTURAL-MECHANICAL SIMULATIONS
Thermo-elastic effects contribute the most to positioning errors in machine tools especially in operations where high precision machining is involved. When a machine tool is subjected to changes in environmental influenc...
EXTENSION OF A PHASE TRANSFORMATION MODEL FOR PARTIAL HARDENING IN HOT STAMPING
The quality of predicted microstructural and mechanical properties in hot stamping simulations relies considerably on the material model. Many researchers studied the effect of the plastic deformation on the phase transf...