Investigation of Mechanical and Welding Defect of Metal Piece Welded Through ARC and TIG Welding

Abstract

To improve welding quality of mild steel plate, an automated Tungsten Inert Gas (TIG) welding system has been developed, by which welding speed can be control during welding process. In this study, Welding of mild steel plate has been performed in two phases. In first phase by using Conventional Arc welding and in second phase by using TIG. The hardness and microstructure of Tungsten Inert Gas (TIG) weld and arc weld of a mild steel joint has been calculated and compared. The hardness of the weld joint and the Heat Affected Zone (HAZ) of a mild steel is important when considering its performance during its application in industries. The process parameters such as current, voltage, gas flow rate and electrode diameter for TIG process are chosen carefully. The hardness test was conducted using the Rockwell hardness scale B while the microstructure was evaluated using the metallurgical microscope. The hardness values in the weld cross section was observed and it was noted that the Weld zone has the highest hardness values followed by the HAZ and finally the base metal. With choice of the process parameters, current was also noted to have highest contribution on the hardness.

Authors and Affiliations

Arata Samantarya, Madhusmita Kumari Das, Janaki Kumari Khillo, Mr. Santosh Kumar Tripathy

Keywords

Related Articles

Heart Rate and Ischemia Detection Using Wavelet Transform

Electrocardiogram (ECG) is generally used for diagnosis of cardiovascular abnormalities and disorders. An efficient method is implemented towards the detection of heart rate (HR) and ischemic from the ECG signal. The he...

A Comparative Performance Analysis of Various CMOS Design Techniques for XOR and XNOR Circuits

XOR and XNOR gates play an important role in digital systems. XOR & XNOR logic gates are basic building blocks of many arithmetic circuits. The XOR and XNOR circuit is implemented in pass transistor logic, static CMOS l...

Performance Prediction of a Gas Turbine Operating on Air Using 3D CFD

In this paper the work is to demonstrate the performance of single stage gas turbine which is able to operate with hot air as a working fluid at specific boundary conditions. These boundary conditions were chosen to be...

A Way Early Tag Access with Partial Tag Comparison Technique for Reducing Power Consumption of L1 Data Caches

In this paper, we propose a new cache design technique, referred to as early tag access (ETA) cache, to improve the energy efficiency of data caches in embedded processors. The proposed technique performs ETAs to determ...

Experimental Study of Coconut Shell Concrete

The rising cost of construction materials in developing countries has necessitated research into the use of alternative materials civil engineering construction. In this study, a concrete mix of 1:1.51:3.06 was used as...

Download PDF file
  • EP ID EP21951
  • DOI -
  • Views 218
  • Downloads 3

How To Cite

Arata Samantarya, Madhusmita Kumari Das, Janaki Kumari Khillo, Mr. Santosh Kumar Tripathy (2016). Investigation of Mechanical and Welding Defect of Metal Piece Welded Through ARC and TIG Welding. International Journal for Research in Applied Science and Engineering Technology (IJRASET), 4(4), -. https://europub.co.uk./articles/-A-21951