Investigation of the reliability of the repaired equipment of automatics and telemechanics

Abstract

The results of studies of the dependence of the average failure rate and mean time between failures of the repaired equipment of automation and telemechanics on the frequency of preventive replacements and the depth of reliability restoration, as well as the coefficient of variation of distributions used to describe equipment failures. It is established that the value of the average failure rate with a decrease in the frequency and number of replacements of repaired equipment before replacement with new equipment decreases, and with a decrease in the depth of restoration of the reliability of the equipment increases. By varying the depth of reliability restoration or the frequency and number of replacements of the repaired equipment before replacement with new equipment, it is possible to provide a set value of the average failure rate of automation and telemechanics equipment. MTBF of the equipment significantly depends on the depth of recovery of reliability when conducting the repair. There are the boundary values of the frequency of replacements and the recovery depth of reliability, in which repair is impractical, as the time to failure of equipment in these cases is lower than in the absence of such repairs. There are limits to the depth of reliability restoration, in which repairs at any frequency reduces the time between failures of equipment and carrying out such repairs is impractical. From the results of research it follows that for the equipment, in which the aging and wear processes are expressed more clearly, the range of expediency of repairs is expanding. The obtained results show that in operating conditions due to changes in the frequency of preventive replacements and the depth of reliability restoration it is possible to provide the required value of the mean time between failures of the equipment.

Authors and Affiliations

V. Volodarsky

Keywords

Related Articles

Features of the introduction of modern digital radio technologies on railway communication networks

A comparative analysis of digital radio technologies DMR, GSM-R and LTE-R was carried out. The principles of construction and basic technical and operational characteristics of radio equipment and directions of use for t...

Determination of the parameters of the distributions evaluated with the coefficient of variation

Determination of the type and parameters of distributions is often associated with difficulties caused by a small amount of statistical data on failures of technical devices. Incomplete initial information means such a s...

Development of requirements for an automated system for managing capacity of the railway infrastructure of Ukraine

To improve the efficiency of the railway transport of Ukraine in the conditions of rail industry reform and the introduction of equal access to the railway infrastructure, based on the development of requirements for an...

Mutual correlation of components of interferences to work of tonal rail circuits

Tonal rail circuits work in the conditions of simultaneous influence of interferences of different type. These interferences in some cases lead to failures in operation of traveling receivers. For increase in their noise...

On optimization of the periodicity of maintenance of devices

To optimize the frequency of maintenance of the proposed generalized mathematical model, and mathematical model of preventive replacements and preventive overhauls, different given the extent of resource recovery and tec...

Download PDF file
  • EP ID EP504438
  • DOI 10.18664/ikszt.v0i1.158800
  • Views 141
  • Downloads 0

How To Cite

V. Volodarsky (2019). Investigation of the reliability of the repaired equipment of automatics and telemechanics. Інформаційно-керуючі системи на залізничному транспорті , 24(1), 19-24. https://europub.co.uk./articles/-A-504438