KINETIC PARAMETERS OF OXIDATION OF IRON IRONS (FE2 +) IN AERIAL DEVICES
Journal Title: Енергетика і автоматика - Year 2018, Vol 0, Issue 4
Abstract
The article deals with the problem of the purification of groundwater from ferrous by forced aeration. It is assumed that the intensification of the oxidation process of ferrous can be achieved by significantly increasing the contact area of the water-air interface, using the method of discrete-pulsed energy input. The purpose of the work is to determine the kinetic parameters of ferrous oxidation in different aeration devices and compare them with the corresponding parameters of the aeration-oxidative setup (AORT) with discrete impulse input of energy. The experimental aeration-oxidative setup is a closed loop system consisting of reactor, aerator-oxidizer, recirculation circuit, cooling jacket, management and control unit, measuring equipment and oxidative and filtration column. The air for aeration of treating water is self-suctioned through an air pipe with an ejector at the end to the air inlet pipe. The air-fed mixture obtained in the ejection zone enters an aerator-oxidizer, consisting of a rotor-pulsating unit and a rotary impeller of a centrifugal pump. The working volume of the aerator-oxidizer is 0.0015 m3. An oxygen-saturated gas-air mixture through the recirculation pipeline returns to the reactor. As parameters for comparison were used: oxidation rate [mol/l∙s], and effective oxidation constant [c-1]. In addition, the energy efficiency of process of deferrization, namely, specific energy consumption, [kWh / m3] was estimated. It is determined that the rate of oxidation of ferrous in AORT exceeds the rate of oxidation in a water ejector by 13-15%, in cooling tower - more than 2 times. Specific energy consumption for treating 1m3 of water in AORT is 40% less than in a water-air ejector and 2.5 times than in a cooling tower.
Authors and Affiliations
О. М. Ободович, В. В. Сидоренко
Keywords
Related Articles
- EP ID EP396889
- DOI -
- Views 69
- Downloads 0
СПОСІБ ПОКРАЩАННЯ ЕНЕРГОЕФЕКТИВНОСТІ АСИНХРОННОЇ МАШИНИ
Суміщення способів подвоєння числа фаз і внутрішньої ємнісної компенсації реактивної потужності в асинхронній машині призводить до активного впливу на кількісні показники обертового магнітного поля - одного з головних уч...
EFFICIENCY OF COMBINED HEAT-UTILIZATION SYSTEMS OF BOILER INSTALLATIONS (PART 2)
The combined heat recovery system of the boiler installation, which is intended for heating the water and heating and humidifying the blowing air, is considered in the work. The results of the analysis of efficiency and...
DEVELOPMENT OF ADAPTATION SYSTEM MAGNETIC INDUCTORS AUTOMATED AGGREGATE MPP
The article presents the principle of operation of the mobile unit of magnetic pulse treatment of plants. Schemes of the automated system of maintenance of the set distance and angle of inclination between inductors and...
COMBINATORY INVARIANT FOR FUNCTION DETERMINED ON A CIRCLE
The article deals with the case of continuous functions with a finite number of local extreme a defined on a one-dimensional compact manifold without boundary. The conditions of topological equivalence of continuous func...
INFLUENCE OF VOLTAGE DEVIATION ON TECHNOLOGICAL AND ENERGY CHARACTERISTICS OF SCRAPER INSTALLATION FOR MAGNIFYING
The voltage deviation from the normalized values has negative consequences, among which the most significant are the violation of the normal course of technological processes, simple enterprises and the issue of poor qua...