КОМПЛЕКС ТЕХНІЧНИХ ЗАСОБІВ ДЛЯ ВИЗНАЧЕННЯ ТЕПЛОТИ ЗГОРЯННЯ ПРИРОДНОГО ГАЗУ
Journal Title: Вимірювальна техніка та метрологія - Year 2018, Vol 79, Issue 2
Abstract
Article is devoted to the issue of selecting a gas representative sample directly of consumer from low-pressure gas pipelines as well as conducting representative studies of the natural gas heat combustion using a direct method with gas calorimeter. Article describes the disadvantages of chromatographic method for determining the heat of gas combustion and indicates the necessity of developing a gas calorimeter. Development of a sampler on the basis of a typical cylinder with the using pneumatic drive of various configurations is proposed. Lack of existing samplers is proved. It is related to the displacement of the gas sample taken with help of excessive air pressure. The latter can significantly change the value of the heat of gas combustion. We have developed a complex of technical means, which consists of a cylinder – dispenser with a pneumatic drive of a «tandem» type cylinder and a gas meter. Applying the «tandem» cylinder as a pneumatic actuator provides additional benefits that are associated with an increase in the overall effort on the drive rod. Developed complex links the piping system of gas pipelines and the calorimetric column, in which the sampling gas is burned directly and the combustion heat is sequentially determined. Mentioned cylinder-dispenser can be used in the mode of the piston sampler, and in the setting mode-dispenser, the metering device of the volumetric flow rate of natural gas. To select the gas sample a method of using the cylinder - the dispenser is developed. While determining of the amount of gas is performed, application of the pulse interpolation procedure aiming accuracy enhancement is proposed. For representative research, the heat of natural gas combustion is measured by direct measurement by calorimeter application with the direct burning of natural gas, and the complex of technical means for carrying out selection, injection, transportation as well as measurement of parameters of gas sample, is developed.
Authors and Affiliations
Igor Petryshyn, Alexander Bas, Lyudmila Prysyazhnyuk
Keywords
Related Articles
- EP ID EP531529
- DOI 10.23939/istcmtm2018.02.005
- Views 71
- Downloads 0
КОМПЛЕКСНА МЕТОДИКА ПРОВЕДЕННЯ МЕТРОЛОГІЧНОЇ ЕКСПЕРТИЗИ ВІЙСЬКОВОЇ ТЕХНІКИ ЗВ’ЯЗКУ
Modern and promising examples of military communication technology belong to the most knowledge-intensive and high-tech types of industrial products, which are subject to increased requirements for quality an...
ІНТЕГРОВАНЕ ФОРМУВАННЯ ПОКАЗНИКІВ ВЛАСТИВОСТЕЙ ДЛЯ КВАЛІМЕТРИЧНОГО ОЦІНЮВАННЯ ПРОДУКЦІЇ
The method of forming the production property indices by dint of benchmarking, reverse engineering and quality function deployment has been suggested. It is shown that using the gained benchmarking information we could c...
Прогнозування та реалізація термоелементів на основі термометричного матеріалу Zr1-xErxNiSn
The temperature and concentration dependencies of resistivity, thermopower and also power descriptions of Zr1-xErxNiSn semiconductor in ranges, T = 80 ¸ 380 K and x = 0 ¸ 0,50, respectively were investigated.
АНАЛІЗ ПРОБЛЕМАТИКИ В СИСТЕМІ МОНІТОРИНГУ ПАРАМЕТРІВ ДОВКІЛЛЯ ТА ЕНЕРГОСПОЖИВАННЯ ПАЛИВНО-ЕНЕРГЕТИЧНИХ РЕСУРСІВ
Strengthening the legislative and international requirements for environmental protection and the need to optimize the energy consumption in the gas transportation system of Ukraine, requires the comprehensive monitoring...
ВЕКТОРНИЙ МЕТОД ОЦІНЮВАННЯ ЯКОСТІ
Vector method of production and service quality estimation through two criteria – a vector and a phase – is proposed.