Low Voltage Mixed-mode Multi Phase Oscillator Using Single FDCCII
Journal Title: Elektronika - Year 2016, Vol 20, Issue 1
Abstract
In this paper a new low voltage mixed-mode multiphase quadrature oscillator employing a single fully differential second generation current conveyor, two resistors and two grounded capacitors is proposed. The proposed circuit provides two quadrature voltage outputs and three quadrature current outputs simultaneously. In addition, the proposed circuit has been made load insensitive so that it is capable of providing high output impedance current outputs without using additional current followers. Moreover, the proposed circuit of load insensitive quadrature oscillator provides four phase current outputs and two voltage outputs, simultaneously. Non-ideal study is also included. Both the proposed circuits enjoy low active and passive sensitivities. This paper further presents an active-C multiphase oscillator with a single FDCCII and two grounded capacitors. The proposed structures are suitable for low voltage applications. Simulation results using PSPICE program on cadence tool are included.
Authors and Affiliations
Jitendra Mohan, Bhartendu Chaturvedi, Sudhanshu Maheshwari
Keywords
Related Articles
- EP ID EP362530
- DOI 10.7251/ELS1620036M
- Views 86
- Downloads 0
Study on a Composite Patch Antenna Based on Left Handed Material with Near Zero Index
In this paper, a composite patch antenna based on left handed material (LHM) with near zero index (NZI) is presented. This composite patch antenna is designed by assembling split resonant rings (SRRs) and metal strips on...
Design of Ternary Content-Addressable Memories with Dynamically Power-gated Storage Cells Using FinFETs
An independent-gate FinFET can operate in two modes: SG (shorted-gate) and IG (independent-gate) modes, and thus a FinFET-based circuit offers rich design options for lower power, better performance or reduced transistor...
Hardware Implementation of FTC of Induction Machine on FPGA
In this paper, a new design method of Direct Torque Control using Space Vector Modulation (DTC-SVM) of an Induction Machine (IM), which is based on Fault Tolerant Control (FTC) is proposed. Due to its complexity, the FTC...
Preventive Thermographic Diagnostic of a HV Busbar Disconnector
For the purpose of increasing quality, continuity and, at the same time, of increasing reliability and decreasing the losses in an electric power system (EPS), there is an emerging need for preventive diagnostic testing....
Fast carrier recovery in FHSS systems with DDS based Costas loop
Owing to fast change of carrier frequency, the usage of coherent demodulation methods in Frequency-Hopping Spread Spectrum (FHSS) communication systems is limited by the coherent state acquisition performed by the local...