MACHINE TAPS FOR CUTTING SCREWS
Journal Title: Подільський вісник : сільське господарство, техніка, економіка - Year 2018, Vol 1, Issue 29
Abstract
The common use of screw joints connections in engineering is caused by their simple construction, high load-bearing capacity, reliability and convenience of connection and disconnection of parts. The high use of screw joints is also explained by the fact that there are a lot of special screw parts adapted to a variety of structures, there is their broad standardization and low cost in terms of mass production. It is known that 60….70% of general machinery parts have screw joins. And the processing of these joints with cutting tools is a complex technological problem, especially in manufacturing the accurate screw holes. Research considers the efficiency performance of taps by means of reducing their breakdowns on the basis of the design of taps, taking into account the changes in their parameters in the process of screw cutting and the state of the individual parts of this tool. The progressive design machine taps for cutting screws are examined in the study. In this construction the deformation angle of the screw increases in terms of continuous teeth cutting teeth to 0.2 degrees and then stabilizes at the simultaneous operation of all the teeth on the winding of 0.175 degrees and gradually decreases when the fluctuations drop to zero when the cut screw teeth leave. On the basis of theoretical research it is recommended to improve the design of the device for cutting screws by curved taps. The advantage of the tap is the improvement of the work conditions: separation of chippings that helps to form a cleaner surface and it is very important when dealing with viscous materials. They also provide a greater density of taps regrinding to avoid joins of the holes and their break-down.
Authors and Affiliations
N. M. Marchuk
Keywords
Related Articles
- EP ID EP535980
- DOI -
- Views 112
- Downloads 0
ACCOUNTING ENSURING OF THE TRANSPARENCY IN THE PUBLIC SECTOR: PROBLEMS OF UKRAINE AND EU EXPERIENCE
Lack of theoretical developments and practical approaches to the study of accounting transparency stipulated the necessity of the study of information transparency in the public sector of Ukraine. The goals of this arti...
ORGANIZATION OF LOGISTICS SYSTEM AT LIGHT INDUSTRY ENTERPRISES
The article deals with the features of formation of the logistics system for light manufacturing. It was concluded that rational traffic control of large body of material resources is impossible without computerization p...
DEVELOPMENT OF BUSINESS ACTIVITIES OF AGRICULTURAL ENTERPRISES UNDER THE CONDITIONS OF DYNAMIC BUSINESS CLIMATE
For the formation of competitive strategies of agricultural enterprises it is necessary to carry out a thorough analysis of the market business climate under conditions of rapid growth of the production and sales leading...
ZOO PLANKTON FAUNA AND ABIOTIC FACTORS OF WATER ENVIRONMENT IN GROWING PONDS
The results of studies on the natural fodder growing ponds. Established that dominant during the season was Bosminalongirostris OF Muller with an average number of 13,2 thousand. Ind/m3, biomass 0,128 g/m3. In growing po...
FINANCIAL CYCLE IN THE MANAGEMENT OF ENTERPRISES WORKING CAPITAL
Companies working capital management in today's economic environment has a number of specific features, the determination of which is an urgent task of financial management. Therefore, the aim of this research is to dete...