Methods of quality control signals in digital radio relay and tropospheric communication station
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2013, Vol 0, Issue 52
Abstract
Introduction. The modern digital communication systems such as radiorelay and tropospheric communication, their advantages before the analogue systems, requirements for digital systems in terms of accurate data transmission and control errors in service monitoring are described. Performance error in digital path. The overview of main error indicators in digital communication systems, approved by international telecommunication union is provided in this section. It contains a brief description of determine the readiness state and error seconds calculation method. Methods for evaluating the quality of digital signal. The questions measuring key indicators of errors that can occur in the digital channel, such as BER - (Bit Error Ratio) and ES -(Error Seconds) are considered. The description of the methods for measuring these indica-tors, so as out of service and in service monitoring is given. The errors detection method used the E1 stream structure and their efficiency is described. The diagnostic methods in the digital path in service monitoring and applications features for authentic definition of the bit errors coefficient based on CRC-4 procedure are compared. One of the methods offers to get probabilistic relations between the parameters based on BER and ES / SES for the evaluation digital path use, using a probabilistic model of the processes occurring in the measurements. Mask of bit errors ratio of the relative measurements time is produced. Conclusions. The methods of control quality signals for errors in digital communication systems compared different approaches for indicating and calculation the main indicators of errors, such as BER and ES/SES are analyzed. It is recommended to use CRC-4 procedure with probabilistic model of the processes occurring in the measurements using distribution mask bit error probability for channels with different bandwidth for the quantitative evaluation the quality radio path.
Authors and Affiliations
G. Bondarenko, A. Zinchenko
Keywords
Related Articles
- EP ID EP309074
- DOI 10.20535/RADAP.2013.52.151-160
- Views 84
- Downloads 0
Method of generalization of influence of the parameters of loadings on the characteristics of UHF units
The method of generalization of influence of parameters of loadings on the characteristics of UHF units that enables to predict changes of the characteristics at inclusion of UHF units in the radioelectronics systems is...
Scattering of the flat waves by symmetrical vibrator with nonlinear load in process work of nonlinear radio locator
Analysis permitting to find the secondary electrical field distribution along the nonlinear load symmetrical vibrator for anyone component and her harmonics when known level of the power and the irradiation UHF field vol...
Method of signal processing on the basis of non-expansive uniformly continuous mapping
In article the method of signal processing on the basis of non-expansive uniformly continuous mapping operating in compact metric spaces which provides construction of effective model of signal patterns classification is...
Optimization of amplitude-frequency characteristic three elements band-pass filter with dielectric resonator by genetic algorithm
It’s proposed the program that is searching the coupling coefficients of dielectric resonators answering to the necessary gain-frequency characteristic of band pass microwave filter. The program is based on a genetic alg...
Features of solving the Electrical Impedance Tomography inverse problem by zones conductivities method
The comparison of the iterative process convergence for the EIT inverse problem solving by classical Newton-Raphson method, regularization method by A. Tyhonov and asymmetric current source connection to zones phantom is...