Modeling of technological processes of treatment drinking water when using the activated coagulant solution

Abstract

The modeling of treatment drinking water technological process using the activated coagulant solution was performed. It was found that the use of an activated solution of aluminum sulfate coagulant allows to reduce the consumption of reagents, improve the quality of water treatment, and increase the productivity of sewage treatment plants. A mathematical model for predicting the efficiency of water clarification using an activated solution of aluminum sulfate coagulant is developed. The mathematical model is developed for the low turbid colored water and water with enhanced content of suspended matter and small colored. For the construction of mathematical models a complete factorial experiment was used in two levels with varying of three factors, which the little turbid colored waters (colored, dose of the entered coagulant, temperature of water) behave to the number of that, for water with enhanced content of suspended matter and small colored the followings factors were accepted: (dose of the entered coagulant and temperature of water). Functional dependences describing the investigated process of water treatment are got, comparison of experimental and calculation data that explain the process of water treatment with the use of the activated solution of coagulant fully enough and can be used in technological calculations at planning of sewage treatment plants of plumbing is executed.

Authors and Affiliations

S. , Dushkin, T. , Shevchenko

Keywords

Related Articles

A study of the of the local energy saving ventilation system effectiveness

Significance of energy saving technologies introduction in the design of new and modernization of old buildings is proved. Work of local energy saving ventilation system for the lecture hall of the University in terms of...

The influence of wave phenomena on operating of hydrotechnical sructures

Paper gives short information about wave phenomena like translational waves and near-critical flows, which can occur within different hydrotechnical structures. It emphases properties of wave phenomena and their influenc...

Development of the electronic catalog of small energy efficient forms for modern architecture

Advanced energy-efficient architectural solutions are a symbol of modern architecture. They also include small energy-efficient forms (SEEF), which work on alternative energy and are increasingly used in modern energy-sa...

Mechanism of highly dispersed chalk additive influence on cement stones structure formation processes

The influence of highly dispersed chalk on cement stones structure has been investigated in the work. The study has shown that chalk contains base cations that are part of most clinker minerals. Chalk surface in water di...

The study of the work of one-contoured systems of solar hot water-supply

The article deals with the issues of the increase of solar energy use in engineering systems of civil buildings. The mathematical model was built and the study of the work of the one-contoured system of hot water-supply,...

Download PDF file
  • EP ID EP326099
  • DOI -
  • Views 131
  • Downloads 0

How To Cite

S. , Dushkin, T. , Shevchenko (2017). Modeling of technological processes of treatment drinking water when using the activated coagulant solution. Вісник Одеської державної академії будівництва та архітектури, 1(68), 139-145. https://europub.co.uk./articles/-A-326099