Modelling of Single Point Cutting Tool Deflection due to Cutting Forces under Variable Side Rake Angle

Abstract

The purpose of this study was to determine the Single point cutting tool deflection due to cutting forces which were developed because of different parameters like feed, depth of cut, cutting speed and also because of geometrical parameters of cutting tool like side cutting edge angle and side rake angle. Firstly the cutting forces were measured using dynamometer. Then finite element method (FEM) was used to obtain the cutting tool deflection which is finite element analysis (FEA). The FEA results were then validated using cantilever beam model results. The predicted results from FEA were very close to the theoretical study. Though the prediction from FEA and the theoretical results are reasonably accurate, FEA modelling seems to be more preferable due to significantly less computational time and space.

Authors and Affiliations

Vishrant Kalasua, Gaurav Tiwari, Ankit Thakur

Keywords

Related Articles

Advancing Informing Frameworks for Secure Part Based Messaging

Distributed computing has been developing widely, including various clients on the administration it gives. Cloud based email is one of administrations gave by distributed computing number of clients developing yearly p...

Diesel Engine with Hydrogen in Dual Fuel Mode: A Review

Depleting fossil fuel resources and increased energy demand forced automobile companies to search clean alternative. There are also Concerns for global warming and tightened emission norms. For this there are different...

slugA Survey– Algorithm For Fault Node Recovery For Wireless Sensor Network

Fault node recovery algorithm is used to increase the life time of wireless sensors network when some node stop working or found to be faulted .This algorithm is a combination of grad...

Multilevel Inverter for Higher Output Voltage Levels

This paper presents the multilevel inverter for higher output voltage levels by using asymmetrical cascaded H-bridge multilevel inverter. The general function of the multilevel inverter is to synthesize a desired high v...

Survey on Efficient Control Algorithm in Cloud for Cost Elaboration

Cloud computing is a new paradigm for delivering remote computing resources through a network. However, achieving an energy-efficiency control and simultaneously satisfying a performance guarantee have become critical i...

Download PDF file
  • EP ID EP19290
  • DOI -
  • Views 251
  • Downloads 4

How To Cite

Vishrant Kalasua, Gaurav Tiwari, Ankit Thakur (2015). Modelling of Single Point Cutting Tool Deflection due to Cutting Forces under Variable Side Rake Angle. International Journal for Research in Applied Science and Engineering Technology (IJRASET), 3(1), -. https://europub.co.uk./articles/-A-19290