MULTI-CRITERIA DECISION APPROACH WITH AHP AND IF-TOPSIS METHODS FOR R&D PROJECT SELECTION PROCESS
Journal Title: Journal of Engineering Studies and Research - Year 2019, Vol 25, Issue 3
Abstract
In this study, we examined the project selection process in a mould manufacturing company. We ranked 12 criteria via Analytic Hierarchy Process (AHP) and evaluated the most important 8 criteria. Then we applied Intuitionistic Fuzzy TOPSIS (IF-TOPSIS) method, which is the extended version of the TOPSIS method in intuitionistic fuzzy environment. After expressing the decision makers' evaluations in linguistic terms, we turned them into intuitive fuzzy numbers. In the last step, we obtained the project rankings by calculating the closeness coefficient for 5 projects
Authors and Affiliations
Keywords
Related Articles
- EP ID EP660880
- DOI 10.29081/jesr.v25i3.328
- Views 79
- Downloads 0
SENSITIVITY ANALYSIS OF AVALANCHE PHOTODIODE AND PIN DIODE DETECTORS IN OPTICAL RECEIVERS
This research explained how to establish the optical receiver sensitivity and the link power budget design in terms of quality factor, receiver power and bit error rate (BER) for several values of attenuation at 100km fi...
THE MODELING OF GRAPHICAL AND ANALYTICAL DRYING PROCESS PARAMETERS RELATIONS IN CO2 ENVIRONMENT
The engineering calculation of such dryer could be approximately done using Id-diagrams. There is such a diagram for air based dryers graphical and analytical calculation. The use of this diagram for CO2 modified environ...
INDUCED DEGRADATION OF CRUDE OIL POLLUTED SOIL BY MICROBIAL AUGMENTATION
This study was aimed at assessing the effectiveness of indigenous microbes for remediation of hydrocarbon contaminated soil by first increasing the population of the indigenous microbes via bioaugmentation. Soil samples...
VIBRATIONAL CASE STUDY FOR THE MOLD OSCILLATOR WITH HYDRAULIC SERVO SYSTEM
We have conducted sensitivity analysis to investigate the two-hydraulic-servo system for the mold oscillator. By modelling mathematical models for operating fluid flow to control a hydraulic cylinder, we changed design p...
ON THE PHOTOLUMINESCENCE AND OPTICAL PROPERTIES OF ZINC OXIDE THIN FILMS PREPARED BY THERMAL OXIDATION
Zinc oxide (ZnO) thin films were prepared by thermal oxidation of vacuum evaporated metallic zinc films. Some structural investigation, performed by X-ray diffraction technique, showed that films are polycrystalline and...