Multi-response Optimization of End Milling Parameters for Al-Zn-Mg/SiC Co-continuous Composite Using Response Surface Methodology
Journal Title: Materials Science-Medžiagotyra - Year 2019, Vol 25, Issue 4
Abstract
A co-continuous ceramic composite (C4) was manufactured by gravity infiltration. The effect of varying machining parameters namely, speed, feed and depth of cut during end milling of C4, on the multi-responses of surface roughness, tool wear and depth of cut was investigated using response surface methodology. Non-linear regression models were generated and optimal machining parameters were determined using desirability analysis. Confirmation experiments performed, validated the models with a ± 5 % error in prediction.
Authors and Affiliations
Prasanth ACHUTHAMENON SYLAJAKUMARI, Ramesh RAMAKRISHNASAMY, Gopalakrishnan PALANIAPPAN, Ramu MURUGAN
Keywords
Related Articles
- EP ID EP674935
- DOI 10.5755/j01.ms.25.4.21000
- Views 51
- Downloads 0
Effect of Sintering Temperature, Sm3+ Concentration and Excitation Wavelength on Luminescence Properties in Eu3+ Doped Strontium Tungstate Phosphors
The color-tunable SrWO4:0.20Eu3+, Sm3+ phosphors are successfully prepared by co-precipitation method at a low temperature (800 °C). These phosphors can be efficiently excited by near-ultraviolet and blue light. The phas...
Investigation of Abrasive Wear Behavior of Industrial Wastes on Al 6061 Material Using Rubber Wheel Abrasion Test (RWAT) Method
In this study, the abrading characteristics of the slags, generated in the form of industrial waste during raw iron, steel and ferrochromium ore production, are investigated. Granulated blast furnace slag (GBFS), basic o...
The Effects of Ink Presence on Mechanical, Physical, Morphological and Thermal Properties of Office and Newspaper Fiber-Polypropylene Composites
In this study the effects of ink (offset and toner) presence on the mechanical, physical, morphological and thermal properties of newspaper- and office paper fiber-plastic composites were investigated. Printed and unprin...
Characterization, Production and Microwave Absorbing Properties of Polyaniline-NiFe2O4: Tb Composites
In this study, terbium-doped NiFe2O4 was produced by using mixed oxide technique. The Ni1-xTbxFe2O4 composition was synthesized and x was selected as 0.025, 0.050 and 0.070, respectively. The single phase Ni ferrite was...
Properties of High Temperature Oxidation of Heat-resistant Steel with Aluminium and Copper
The research is focused on a novel aluminum and copper-containing heat-resistant steel. The steel was designed by the material performance simulation software JmatPro, performed high-temperature oxidation tests at 650 °C...