Nanostructured zirconia layers as thermal barrier coatings
Journal Title: INCAS BULLETIN - Year 2011, Vol 3, Issue 3
Abstract
The coatings obtained by thermal spray are used both as antioxidant and connection materials (e.g. MCrAlY type alloys) as well as thermal barrier coatings (e.g. partially stabilized zirconia oxide with yttria oxide). This paper studies the characteristics of the coatings obtained with nanostructured powders by thermal spraying and air plasma jet metallization. Testing of coatings is done against the most disturbing factor, thermal shock. Structural changes occurring after thermal shock tests are highlighted by investigations of optical and electronic microscopy. The results obtained after quick thermal shock show a good morphological and surface behavior of the developed coatings.
Authors and Affiliations
Sorina ILINA, Gheorghe IONESCU, Victor MANOLIU, Radu Robert PITICESCU
Keywords
Related Articles
- EP ID EP129652
- DOI 10.13111/2066-8201.2011.3.3.7
- Views 78
- Downloads 0
Estimation of Wind Tunnel Corrections Using Potential Models
The evaluation of the tunnel correction remains an actual problem, especially for the effect of tunnel walls. Even if the experimental campaign meets the basic similitude criteria (Mach, Reynolds etc.), the wall effect o...
The unsteady turbulent flows structure study present status
The processes of heat transfer and hydraulic plays a very important role in the design and prototyping of aerospace technology. In most cases this technique works under significant unsteady conditions. Steady approach fo...
Unmanned aero-amphibious vehicle: preliminary study on conceptual design
This research paper deals with the methods of designing of an unmanned aero-amphibious vehicle finally allowing its manufacture. The design does not includes only the structure and electronics circuit but also the contro...
Professsor ION STROESCU’s activities and achievements at the Polytechnic School and the University of Bucharest
The completion of the mathematical model by parameter identification for simulating a turbofan engine
The purpose of this paper is to set up a method to determine the missing engine design parameters (turbine inlet temperature T3T, airflow rate) which significantly influence the jet engines thrust. The authors have intro...