A review of thermographic techniques for damage investigation in composites
Journal Title: Frattura ed Integrità Strutturale - Year 2014, Vol 8, Issue 27
Abstract
The aim of this work is a review of scientific results in the literature, related to the application of thermographic techniques to composite materials. Thermography is the analysis of the surface temperature of a body by infrared rays detection via a thermal-camera. The use of this technique is mainly based on the modification of the surface temperature of a material, when it is stimulated by means of a thermal or mechanical external source. The presence of defects, in fact, induces a localized variation in its temperature distribution and, then, the measured values of the surface temperature can be used to localize and evaluate the dimensions and the evolution of defects. In the past, many applications of thermography were proposed on homogeneous materials, but only recently this technique has also been extended to composites. In this work several applications of thermography to fibres reinforced plastics are presented. Thermographic measurements are performed on the surface of the specimens, while undergoing static and dynamic tensile loading. The joint analysis of thermal and mechanical data allows one to assess the damage evolution and to study the damage phenomenon from both mechanical and energetic viewpoints. In particular, one of the main issues is to obtain information about the fatigue behaviour of composite materials, by following an approach successfully applied to homogenous materials. This approach is based on the application of infrared thermography on specimens subjected to static or stepwise dynamic loadings and on the definition of a damage stress, D, that is correlated to the fatigue strength of the material. A wide series of experimental fatigue tests has been carried out to verify if the value of the damage stress, sigmaD, is correlated with the fatigue strength of the material. The agreement between the different values is good, showing the reliability of the presented thermographic techniques, to the study of composite damage and their fatigue behaviour.
Authors and Affiliations
Laura Vergani, Chiara Colombo, Flavia Libonati
Keywords
Related Articles
- EP ID EP151916
- DOI 10.3221/IGF-ESIS.27.01
- Views 58
- Downloads 0
On the notch sensitivity of cast iron under multi-axial fatigue loading
This work deals with the notch sensitivity of sharp notches under multi-axial fatigue loading. The main discussion concerns the differences in notch sensitivity at high cycle fatigue regime, between tensile, tors...
Growth of long fatigue cracks under non-proportional loadings – experiment and simulation
An experimental campaign was carried out on thin-walled tubes under tension and torsion. The results from experiments are measured and compared. It is observed that cracks follow a shear-dominated growth pattern...
Resistenza a fatica di strutture in leghe di alluminio: normative a confronto e verifica sperimentale
Le problematiche relative all’utilizzo delle normative nell’ambito della progettazione a fatica di strutture in leghe di alluminio sono state di recente affrontate in numerosi lavori che hanno messo in luce sia le diffic...
Mechanisms of plastic instability and fracture of compressed and tensile tested Mg-Li alloys investigated using the acoustic emission method
The results of the investigation of both mechanical and acoustic emission (AE) behaviors of Mg4Li5Al alloy subjected to compression and tensile tests at room temperature are compared with the test results obt...
Fatigue life assessment of thin-walled welded joints under non-proportional load-time histories by the shear stress rate integral approach
Fatigue life tests under constant and variable amplitude loadings were performed on the tube-tube thin-walled welded specimens made of magnesium (AZ31 and AZ61) alloys. The tests included pure axial, pure torsiona...