AlN thin Film Coated Cu Substrates as Heat Sink for High Power LED Applications
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 2, Issue 12
Abstract
Heat generates from power electronics must be dissipated to maintain operating temperatures within specification. Thermal management is an important design consideration in which thermal interface material (TIM) plays important role on reducing the thermal resistance between hot and cold points. AlN thin film and AlN/Al stack were used as TIM and Cu substrates was used as heat sink. The observed total thermal resistance (Rth-tot) was low for AlN thin film coated Cu substrate. Noticeable decrease in junction temperature (TJ) rise (∆TJ = 6 °C) was recorded for the LED using AlN thin film as TIM. AlN and AlN/Al thin film stack were not supported to enhance the luminosity of the given 3W LED but driving current influenced on optical properties noticeably.
Authors and Affiliations
S. Shanmugan*1
Keywords
Related Articles
- EP ID EP158913
- DOI -
- Views 75
- Downloads 0
CONTROL STRATEGY RESEARCH AND SIMULATION FOR MMC BASED ON PDSPWM
Modular multilevel converter was hot in the research field of high-voltage power converter, for its advantages of small switching loss, independent device tandem technology. Then, the principles of MMC for the PD-SPWM wa...
CFD SIMULATION AND EXPERIMENTAL VERIFICATION OF AIR FLOW THROUGH HEATED PIPE
The aim of this work is to validate the Dittus-Boelter equation by experimental, correlation and Simulation method. It used to find the value of heat transfer coefficient ‘h’ for turbulent flow in many fluid trans...
SOFTWARE PERFORMANCE PREDICTION USING RANDOM FOREST BASED REGRESSION ANALYSIS
The evaluation of various software quality metrics like performance, reliability, and response time are done usingquantitative techniques and it is essential for component based software applications. In this paper...
Development and Properties of Hybrid Composites
The Flexural and tensile properties and Scanning electron Microscope analysis of Aramide/Onion/Glass fibers Reinforced Epoxy Reinforced composites are studied. The effect of the Aramide/Onion/Glass fibers on these...
STUDY AND ANALYSIS OF WEAR AND MICRO STRUCTURAL CHANGES ON CAST IRON UNDER LASER TREATMENT
In this thesis Fiber laser techniques are used for the surface engineering of engine cylinder liner. Laser hardening produces wear resistant tracks by microstructural transformations. In this work application of t...