Energetic Influence of Motor Power in Drive Systems with Space-Vector Static Converters and Induction Motors
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2015, Vol 39, Issue 39
Abstract
The static converters are a vital component of modern drive systems, which in turn are indispensable in industrial equipment designed for small or large complexity, because the achievement of finished goods implies the adjustable mechanical energy available at the output of the system. The aim of this paper is the energetic analysis of two drive systems with the same static converter feeding two different motors which had been performed on an experimental stand for different static operating points. It was considered feeding the both asynchronous motors from the static converter using the space vector modulation command strategy while the mechanical load was assured by a special braking machine and by a DC motor, respectively. It had been taken into consideration feeding the both motors at the same frequencies and with the same RMS voltages. The frequencies considered for the energetic analysis are 20Hz, 30Hz, 40Hz and 50Hz, the mechanical load being adjusted from no load operation up to the nominal value. The power grid energetic parameters were recorded using a Fluke 41b harmonic analyzer, while the current and voltage waveforms at the motor input, were recorded using a Metrix Ox704 digital oscilloscope and later used in Matlab to calculate the AC electric powers.
Authors and Affiliations
Mihaita Linca, Constantin Vlad Suru, Alexandru Bogdan Lupu
Keywords
Related Articles
- EP ID EP143616
- DOI -
- Views 128
- Downloads 0
FUEL PUMP WITH INJECTION PRESSURE CHAMBER FOR A JET ENGINE AFTERBURNING SYSTEM
This paper deals with a fuel pump with injection chamber, used as main fuel supplying system for an afterburning system, which can be able to serve on a jet engine (single-jet or twin-jet). The fuel system consists of: f...
Dynamic State of Low Power Asynchronous Motors in Direct-on-Line Starting
The research opportunity is explained by the results obtained in modelling and simulation of asynchronous motors, in the purpose of increasing their technical and economic performances when they operate in dynamic states...
GEOMETRY OPTIMIZATION OF SMES COIL
Superconducting Magnetic Energy Storage (SMES) device is an attractive solution for energy storage. Because the most important element of SMES system is toroidal superconducting coil, the cryogenic technology involved in...
Rotor flux oriented control on the rotor side of the induction motor
In heavy duty drives, in the range of hundreds kW, wound rotor induction motors are widely used. It is the case of cement and minerals industries. Major users make use of tens of such drives, summing hundreds of MW. Due...
DATA ACQUISITION AND PROCESSING SYSTEM FOR SMART MEASUREMENT OF POWER IN HV GRIDS BY OPTOELECTRONIC MEANS
The present concerns related to the smart use of energy require changes in the way in which the electric energy consumption management should be performed, under the circumstances connected to the assurance of electric e...