Fuzzy Rule Based Model for Optimal Reservoir Releases
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2014, Vol 4, Issue 6
Abstract
The aim of this paper is to develop a Fuzzy Rule Based(FRB) model for obtaining the optimal reservoir releases. The area considered for the study is ukai reservoir project. The data considered are for the months of July, August, September and October for the years 2007 and 2011. The inputs considered are inflow (MCM), Storage (MCM), Demand (MCM) and the Release (MCM) is considered as output. Fuzzy logic, analysis is based on designing of if and then rules. Fuzzy logic model can handle with various kinds of data regulations implication and defuzzification. The steps involved in the development of the model include the construction of membership functions, creating the Fuzzy rules, implication and deffuzification. The results obtained shows that the releases obtained from the FRB model are satisfying the demand completely in all the four months, i.e. July, August, September and October for the year 2007 and the same is observed for the year 2011. Also, a significant amount of water is being saved, when the actual releases are compared with the releases obtained from the FRB model.
Authors and Affiliations
Dr. T. M. V. Suryanarayana, Mihir Kemkar
Keywords
Related Articles
- EP ID EP116132
- DOI -
- Views 134
- Downloads 0
XML Based Reverse Engineering System
Abstract: Reverse engineering that gets data such as an original document or design technique by tracing reversely from certain software system is required in the sides of maintenance and reuse. This paper describe...
Taguchi Analysis of Erosion Wear Maize Husk Based Polymer Composite
Amids the growing concern on environmental issues, science is seeking various alternatives to replace the synthetic and non degradable fibers composites with environment friendly biocomposites of comparable cha...
Performance Analysis of Single Phase Inverter
In this paper performance of Single Phase Inverter is discussed. In this case IGBT & GTO switches are used with Sinusoidal Pulse Width Modulation technique. First of all two models are developed using SIMULINK to...
Experimental and Analytical Study on Reinforced Concrete Deep Beam
ABSTRACT: Several reinforced concrete deep beams with different L/D ratios (1.5, 1.6, 1.71) were cast and tested in order to investigate the strain distribution pattern at mid-section of the beam. This paper descri...
A New Method Based On the Comparison of the Unique Chain Code to Detect Isomorphism among Kinematic Chains
This paper presents a new method for the detection of isomorphism in kinematic chains which plays an important role in structural synthesis of kinematic chains. The proposed method uses a new invariant i.e. a unique chai...