Research on parameters optimization of bilateral ring gear blank-holder in thick-plate fine blanking
Journal Title: Frattura ed Integrità Strutturale - Year 2014, Vol 8, Issue 30
Abstract
To compensate for the poor quality of thick-plate blanking parts in cross-section, this paper suggests using the optimizing bilateral ring gear holder parameters to increase burnish zone and improve cutting precision. With the bilateral gear ring, the hydrostatic pressure of shear deformation zone will increase, plasticity of the material will be lifted to maximum and quality of the cross section will be raised. This paper establishes 8mm AISI-1020 fine blanking model by DEFORM2D, analysis different ring gear parameters and clearance that are influenced the stress-strain and cross section quality to predict forming defects. By using the bilateral gear ring blank holder, the poor quality of thick-plate blanking section is successfully enhanced. Therefore, the bilateral gear ring blank holder is vital to improve the quality of blanking parts and provide the reliable theory basis for the practical engineering application.
Authors and Affiliations
C. Su, X. Dong, S. Guo, Q. Li, T. LI
Keywords
Related Articles
- EP ID EP147682
- DOI -
- Views 82
- Downloads 0
Comparative study of multiaxial fatigue methods applied to welded joints in marine structures
Marine structures are particularly prone to action of waves, winds and currents with stochastically varying composition, intensities and directions. Therefore, resultant stresses may cause multiaxial fatigue in&nb...
Stress-state dependent cohesive model for fatigue crack growth
In the cohesive framework, a stress-state dependent cohesive model, combined with an irreversible damage parameter has been used in simulation of fatigue crack growth initiation and continued growth. The model is...
Integrated assessment procedure for determining the fracture strength of glass components in CSP systems
The structural integrity and reliability of glass components are key issues for concentrated solar power (CSP) systems. For example, the glass windows in a solar furnace may suffer catastrophic fracture due to th...
Fracture toughness of TiAl-Cr-Nb-Mo alloys produced via centrifugal casting
Fracture toughness of a TiAl base intermetallic alloy has been investigated at room temperature. The Ti-48Al-2.5Cr-0.5Nb-2Mo (at. %) alloy produced via centrifugal casting exhibits fine nearly lamellar microstructu...
Crack propagation in micro-chevron-test samples of direct bonded silicon-silicon wafers
Wafer bonding describes all technologies for joining two or more substrates directly or using certain intermediate layers. Current investigations are focused on so-called low temperature bonding as a special direct bondi...