NODULAR CAST IRON FATIGUE LIFETIME IN CYCLIC PLANE BENDING
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 3
Abstract
The fatigue behavior of a component is strongly dependent also on the material and its surface condition. Therefore, the manner in which the surface is prepared during component manufacturing (surface roughness, residual stresses etc.) has a decisive role in dictating the initiation time for fatigue cracks. The fatigue behavior of the same material, a nodular cast iron, with three different surface conditions (fine ground, sand blasted and as-cast) has been investigated under cyclic plane bending. The results show differences in fatigue strength, which are associated with the surface conditions. The characteristics of the surface layers of the different test specimens were examined by metallography.
Authors and Affiliations
Marián Kokavec, Radomila Konečná, Gianni Nicoletto
Keywords
Related Articles
- EP ID EP103424
- DOI -
- Views 95
- Downloads 0
Influence of the surface finishing on electrochemical corrosion characteristics of AISI 316L stainless steel
Stainless steels from 316 group are very often and successfully uses for medical applications where the good mechanical and chemical properties in combination with non-toxicity of the material assure its safe and long te...
STRUCTURAL DEGRADATION OF HETEROGENEOUS WELDED JOINTS
Developing the techniques of welding materials with higher dynamic strength onto the rolling surfaces of rails is one of the options for increasing their operational endurance. The subject of this paper is an analysis of...
Fatigue Crack Propagation Under Variable Amplitude Loading Analyses Based on Plastic Energy Approach
Plasticity effects at the crack tip had been recognized as “motor” of crack propagation, the growth of cracks is related to the existence of a crack tip plastic zone, whose formation and intensification is accompan...
EFFECT OF SHOT PEENING ON FATIGUE PROPERTIES OF STEEL IN DIFFERENT STRUCTURAL STATES
The aim of this paper is to evaluate the effect of shot peening on fatigue properties of dual-phase steels DP 600 in received condition, as well as in condition after different regimes of heat treatment. In the work, the...
CORRELATION BETWEEN HARDNESS AND TENSILE PROPERTIES IN ULTRA-HIGH STRENGTH DUAL PHASE STEELS – SHORT COMMUNICATION
The possibility to predict yield strength, strength limit, fatigue live estimation as well as other mechanical properties depending on values of materials hardness is commonly known and it is often used in practice. The...