Non Newtonian Behavior of Blood in Presence of Arterial Occlusion
Journal Title: American journal of Engineering Research - Year 2016, Vol 5, Issue 10
Abstract
The objective of the present numerical model is to investigate the effect of shape of stenosis on blood flow through an artery using Bingham plastic fluid model. Blood is modeled as Bingham plastic fluid in a uniform circular tube with an axially symmetric but radially non symmetric stenosis. The expressions for flux, dimensionless resistance to flow with stenosis shape parameter, stenosis length and stenosis size have been shown graphically.
Authors and Affiliations
Dr. Arun Kumar Maiti
Performance of an Up-Flow Anaerobic Sludge Blanket Reactor (Uasbr) In the Treatment of Brewery Effluent
Brewery waste stream is a high biodegradable with BOD in the range of 2500 to 3500 mg/l and COD from 4600 to 7000 mg/l. This waste stream suffers substrate inhabitation in conventional biological treatment process. Up fl...
Reduced Levelized Cost ofEnergythrough Optimization of Tower Height, Rotor Diameter And\Wind Farm Layout
Wind power has become the most important renewable energy source. Two factors are mainly influencing its future development: scarcity of sites and levelized cost of energy (LCoE). By a site specific turbine and wind park...
Modeling and Analysis of Floating-Ring Bearing ThermoHydrodynamic Parameters for Advanced Turbo-Rotor Systems
This work presents a detailed analysis and modeling of floating-ring bearings (FRBs) for predicting their dynamic-force coefficients, thermo-hydrodynamic characteristics, and instability behavior. The mathematical model...
Simulation of Green-Wave Traffic Control System in RoadNetworks
Trafficcongestions at intersections cause delay, which leads to economic losses in travel time, vehicle operating costs and environmental pollution from vehicular emissions. Vehicles moving through several traffic signal...
Study and Modelisation the Parameters of Plate Solar air Collector at Single Pass for Drying of Madagascar CocoaBeans
In this paper, the authors discuss an experimental study and modelisation of the parameters of a plane solar collector at single pass.The authors construct a prototype of the indirect solar dryer, in order to compare the...