NUMERICAL ESTIMATES OF ELECTRODYNAMICS PROCESSES IN THE INDUCTOR SYSTEM WITH AN ATTRACTIVE SCREEN AND A FLAT RECTANGULAR SOLENOID
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 2
Abstract
Purpose. To carry out numerical estimates of currents and forces in the investigated inductor system with an attractive screen (ISAS) and determine the effectiveness of the force attraction. Methodology. The calculated relationships and graphical constructions were obtained using the initial data of the system: induced current in the screen and sheet metal; the distributed force of attraction (Ampère force); the repulsive force acting on the sheet metal (Lorentz force); amplitude values of the force of attraction and repulsion; phase dependence of the force of attraction, the repulsive force and the total resulting force. Results. The results of calculations in the form of graphical dependencies of electrodynamic processes in the region under the conductors of a rectangular solenoid of inductor system with an attracting screen are presented. The graphs of forces and currents in region of dent are obtained. In the paper the analysis of electrodynamics processes for whole area under the winding of inductor system with an attractive screen is shown. The flowing this processes in the region of dent a given geometry is presented. Originality. The considered inductor system with an attractive screen and a rectangular solenoid is improved, in comparison with the previous developed ISAS. It has a working area under the lines of parallel conductors in the cross section of a rectangular solenoid, and this allows to place a predetermined portion of the sheet metal anywhere within the working region. Comparison of the indicators of electrodynamics processes in the considered variants of calculation shows an approximate growth of almost 1.5 times the power indicators in the area of the accepted dent in comparison with similar values for the entire area under the winding of the ISAS. Practical value. The results obtained are important for the practice of real estimates of the excited forces of attraction. With a decrease in the dent, the amplitude of the electrodynamics forces being excited is growing proportionally (for example, when the depth decreases by 3 mm, the forces increase more than 2 times). The highest efficiency of force attraction is for sheet metal regions, the dimensions do not exceed the transverse dimensions of the winding branches of the exciting solenoid.
Authors and Affiliations
E. A. Chaplygin, M. V. Barbashova, A. Yu. Koval
Keywords
Related Articles
- EP ID EP486226
- DOI 10.20998/2074-272X.2018.2.09
- Views 57
- Downloads 0
MASS AND COST FIGURES FOR SPATIAL AXIAL THREE-PHASE ELECTROMAGNETIC SYSTEMS WITH CIRCULAR AND HEXAGONAL FORMING CONTOURS OF TWISTED MAGNETIC CORE RODS
For a spatial three-phase axial electromagnetic system with double-contour phase elements of the twisted butt-end magnetic core, analytical dependences for optimal geometrical relations determination over minimum active...
INTENSITY SETTER FOR A DEVICE OF SMOOTH START OF SUBMERSIBLE PUMP ELECTRIC MOTOR
Purpose. Development of an intensity setter, which in a rational law changes the opening thyristor the voltage regulator and effectively to changing power supply voltage stator windings of the electric pump deepening, en...
EFFECT OF THE THICKNESS OF INSULATION OF PROTECTED WIRES OF HIGH-VOLTAGE OVERHEAD TRANSMISSION LINES TO THEIR CURRENT CARRYING CAPACITY
Introduction. The main direction of technical policy in the design, construction and technical re-equipment of transmission lines is the modernization of electrical networks and increase their energy efficiency in order...
V.G. Dan'ko
In the article the fault current limiter of inductive type with high-temperature superconducting coil and screen is considered. Main features of transient at occurrence of short circuit are analyzed.
SLIDING MODE CONTROL OF THE DFIG USED IN WIND ENERGY SYSTEM
This paper, presents the application of the direct vector control using the sliding mode control (SMC) on the doubly fed induction generators (DFIG). The synthesis of the control laws is based on the model obtained by th...