One of Two Conductors in Capacitor Substitute by Mercury
Journal Title: Bonfring International Journal of Power Systems and Integrated Circuits - Year 2014, Vol 4, Issue 1
Abstract
Each capacitor generally consists of two conductors separated by a non-conductive region, however a great changed happened in the modern capacitors but the principle has been remained the same as the first day designed. In this paper was attempted to show novel capacitor which one of the conductors was coated and covered with dielectric and sunk into another conductive liquid which supposed as conductor and it is mercury because of two important features, the first being conductive and second the liquidity. In this paper experimented by the lacquer coated wire and the aluminum plate submerged into mercury then in experiments mercury charged and discharged, as a result it was working as a capacitor. The experiments was done by following sets: a DC power supply (DF1730 SB5A), multimeter, an LC meter (A6243- HONEYTEK).the experiment results showed that mercury could appropriately substitute by one of two conductors in capacitors. In addition, the simulation will have higher capacity till one farad and more.
Authors and Affiliations
Mohammad Mehdi Masoumi , Soheila Naderinezhad
Keywords
Related Articles
- EP ID EP115889
- DOI 10.9756/BIJPSIC.10269
- Views 112
- Downloads 0
Simulation Model of Solar Induction Motor Drive System Using SVPWM Technique
Economic development of a country depends upon the basic resources available. The overall economic growth and development of a country of the energy, Solar energy based vitality is a fabulous wellspring of renewable vita...
Fuzzy Approach to Nodal Reliability Ranking for Radial Distribution Networks
Power distribution systems are exposed to load swings and faults, which can lead to voltage instability and collapse. It's important for a distribution engineer is to identify the sensitive nodes so that corrective actio...
Design and Implementation of Op-Amp Based Low-Power CMOS Bandgap Voltage Reference with Minimum Supply oF 0.8-V
A low power voltage source is generated by altering the device size in existing topology has been presented. Bandgap voltage reference is generated by combination of start-up, supply independent, operational amplifier (O...
Shape and Size Dependent Electronic Properties of GaAs/AlGaAs Quantum Dots
We have theoretically investigated the effect of shape anisotropy and size on electronic structure of GaAs/AlGaAs quantum dots (QDs). The quantum dot is modeled by anisotropic parabolic confinement potential in the plane...
PMG Based Wind Energy Conversion System with Closed Loop Boost Converter
This paper presents a system in which a wind Permanent Magnet Generator (PMG) feeds an isolated load through a Closed Loop Boost Converter (CLBC). The output voltage and frequency of the PMG is variable in nature due to...