Open loop control of piezoelectric tube transducer
Journal Title: Archives of Mechanical Technology and Materials - Year 2018, Vol 38, Issue
Abstract
This paper is focused on the open loop control of a piezoelectric tube actuator, hindered by a strong hysteresis. The actuator was distinguished with 22 % hysteresis, which hinders the positioning of piezoelectric actuator. One of the possible ways to solve this problem is application of an accurate analytical inversed model of the hysteresis in the control loop. In this paper generalized Prandtl-Ishlinskii model was used for both modeling and open loop control of the piezoelectric actuator. Achieved modeling error does not exceed max. 2.34 % of the whole range of tube deflection. Finally, the inverse hysteresis model was applied to the control line of the tube. For the same input signal (damped sine 0.2 Hz) as for the model estimation the positioning error was max. 4.6 % of the tube deflection. Additionally, for a verification reason three different complex harmonic functions were applied. For the verification functions, still a good positioning was obtained with positioning error of max.4.56 %, 6.75 % and 5.6% of the tube deflection.
Authors and Affiliations
Frederik Stefański, Bartosz Minorowicz
Keywords
Related Articles
- EP ID EP535848
- DOI 10.2478/amtm-2018-0004
- Views 63
- Downloads 0
Stabilisation problem in biaxial platform
The article describes investigation of rolling ball stabilization problem on a biaxial platform. The aim of the control system proposed here is to stabilize ball moving on a plane in equilibrium point. The authors propos...
Numerical and experimental analyses of non-energy absorbing lighting poles
Apart from the strength requirements, modern lighting pole designs have to meet a number of safety requirements in the event of collisions. The paper compares the experimental tests performed at the collision test track...
TOOLING SELECTION IN TECHNOLOGICAL PROCESSES USING NEURAL NETWORKS
The idea of the author’s research is to develop a system aiding the design of a technological process (a CAPP system), namely a system for creation of a technological process plan, in which the sequence of technological...
Wear Analysis of Cemented Carbide during Turning of Cast Iron Considering Economical Machining Speed
The purpose of this paper is to find economical machining speed during turning of grooves for piston rings with various feeds. In the first part of the paper, literature analysis concerning durability of cutting tools is...
The reliability of reproducing automotive components made by FDM printing in reverse engineering
The purpose of the article is to show the practical side of reverse engineering. Many times during the process of optimizing parts, before we intervene in the tool that produces them, we want to be sure that the optimiza...