Operational Study of Circulating Fluidized Bed Steam Generator
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 6
Abstract
The paper aims at studying the operation of a lignite fired Circulating Fluidized bed Combustion steam generatorof 250 MW capacity located at NeyveliinTamilnadu in South India. Circulating fluidized bed combustion(CFBC) is a techno-economical alternative to conventional pulverized coal fired combustion. It is a clean coal technology and is environment friendly. From the proximate analysis,the lignite consisted of moisture (50%), sulphur (0.70%), ash (8.50%). From the ultimate analysis, the elemental composition were carbon (27.50%), hydrogen (2.20%), sulphur (0.70%) and oxygen (10.40%), nitrogen (0.20%) were found. The operational study was doneand the particle size was one of the main factor for the efficiency. Finer particles consume auxiliary power while coarser particles due to their inertia are difficult to entrain.
Authors and Affiliations
S. Bharath Subramaniam
Keywords
Related Articles
- EP ID EP256306
- DOI -
- Views 93
- Downloads 0
Investigation of Mechanical Properties and Machining Behaviour of Aluminium Alloy Filled withWalnut Cell Micro Particles
The use of aluminium alloys in manufacturing industries has increased significantly in recent years. This is primarily because of their ability to combine lightness and strength in a single material. Concomitant to his g...
Model of Estimation of Success of Geological Exploration in Perspective
In this article discusses the development of a system of interrelated mathematical models, algorithms and programs of the decision task according to the assessment, forecasting and risk management to reduce their values...
CHARACTERIZATION OF ADDITIVE MANUFACTURED ABS AND NATURAL ABS SPECIMENS
Additive Manufacturing (AM) is a Rapid Prototyping technique. It is used for producing any real complex parts from the desired 3D CAD models. It can also manufacture prototypes. Additive Manufacturing can utilize raw mat...
A Study on the Effects of Heat Treatment on the Mechanical Properties of Aluminium Alloy (ADC 12) Reinforced With Iron Oxide (FE2O3)
The mechanical properties of an Al–Si–Cu alloy (ADC12) reinforced with iron oxide, produced using different Heat treatment to process is examined experimentally. Experimental studies were carried out for ADC 12, ADC 12 +...
A Study on Calculation of Optimum Gear Ratios of a Two-Stage Helical Gearbox with Second Stage Double Gear Sets
The article focuses on finding optimum calculation of the gear ratios of a two-stage helical gearbox with second stage double gear sets. To obtain the optimum gear ratios, an optimization problem was established. Besides...