Оптимальне розташування вирівнювальної пластини в конструкції дифузора для підвищення тискових та витратних характеристик вентиляційних систем
Journal Title: Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва" - Year 2016, Vol 0, Issue 844
Abstract
At work investigates the incoming flow and its alignment to the ventilation system elements, located directly outside a radial fan. The efficiency of the ventilation system depends on the improvement of its aerodynamic components. Of great importance are placed the elements directly outside a radial fan. The attention paid to the improvement in work mode energy efficiency of ventilation systems alignment the incoming flow of radial fan the variable modes of its work. In the article experimental studies determined the optimal location of the line-up plate in the design of the diffuser to improve the characteristics of pressure and supplies ventilation systems. These studies carried out depending on the distance from the location of line-up plate side wraps fan and hollow plate in the fan casing outlet, increasing its relative length. The research results can be used to improve the energy efficiency of ventilation systems with radial fans. An effective means of improving the performance of air and pressure in ventilation systems, improving their structural elements situated after the discharge pipe radial fan. The dependencies impact location leveling plate in the diffuser attached directly to the radial fan to change the aerodynamic characteristics of the ventilation system
Authors and Affiliations
B. Gulay, H. Myronyuk, O. Omelchuk, V. Shepitchak
Keywords
Related Articles
- EP ID EP230208
- DOI -
- Views 98
- Downloads 0
АНАЛІЗ ЗА ДОПОМОГОЮ МАТЕМАТИЧНОГО МОДЕЛЮВАННЯ ЗАЛИШКОВОЇ НЕСУЧОЇ ЗДАТНОСТІ ІСНУЮЧИХ ЕЛЕМЕНТІВ КОНСТРУКЦІЙ ПРИ ПІДСИЛЕННІ
During the operation of the building there are situations when it is necessary to change the planning decision, which leads to interference in the bearing elements of the structure. Strengthening of any element of design...
COMPARING OF THE VOLUME OF STORMWATER RUNOFF FROM TYPICAL RESIDENTIAL CATCHMENTS IN LARGEST CITIES, CALCULATED ACCORDING TO UKRAINIAN NORMATIVE DOCUMENTS
It was analyzed Ukrainian normative documents, regulating the procedure of calculating the average annual volume of stormwater runoff from urbanized areas. It was found the big differences as in the numerical values of t...
ВПЛИВ ВОДЯНИХ СТРУМЕНІВ ВІЯЛОВОГО ТИПУ НА ТЕПЛОВИЙ ЗАХИСТ ПІД ЧАС ПОЖЕЖ
The article deals with the following methods of protection of personnel from thermal radiation during fire, such as the use of heat-shielding suits, heat-reflective screens and water curtains. The tactical and technical...
Покращення експлуатаційних властивостей керамічної цегли поверхневим модифікуванням поверхні
In the article there are substantiated and determine the optimal composition of protective covering by the mathematical planning method with taking into account the influence of protective covering on water absorption, a...
MECHANICAL AND PHYSICAL PROPERTIES OF LOW-ENERGY MULTICOMPONENT CEMENTS
One of the main tasks of building industry is to reduce carbon dioxide emissions, which are generated during the cement production, without losing the properties and quality of the binding agent. Production of composite...