Optimization of the Parameters of the Heat Network Under a Reduced Temperature Schedule
Journal Title: Вентиляція, освітлення та теплогазопостачання - Year 2018, Vol 27, Issue
Abstract
The economic and environmental problems of Ukraine lead to decrease the water temperature in heat supply systems. Increasing the cost of fuel made it inappropriate to schedule temperature 95/70. To switch to a lower temperature schedule, at first it is necessary to ensure the automation of the regulation of individual heat points. Only after that it is possible to use reduced temperature schedules. This is confirmed by the successful experience of countries where central heating is widely used: Denmark, Germany, Finland, Sweden, Holland, etc. Modernization of the heat supply systems of Ukraine should go through transition to independent heating systems with qualitative and quantitative regulation, after which the temperature schedule can be reduced to appropriate values. A numerical study of the optimal temperature and water flow in the heat network depending on the design and operating parameters has been carried out. In addition, the results of field studies of the heating characteristics of residential buildings and administrative buildings, the heat supply of which is carried out from two big sources of Kharkov, were used. The entropy production in the heat supply system is numerically determined depending on the design and operating parameters. As a result of the computational experiment, when using entropy production as an optimization criterion, the parameters of the reduced temperature schedule of the heat supply system for the conditions of Kharkiv were determined and substantiated. The results of the numerical study show that the parameters of the heat network at maximum heat load and outdoor air temperature (-25 °C) are as follows: the temperature of the supply network water is 76.7 °C; heat carrier flow rate is 5.7 kg/s, velocity is 0.73 m/s, specific pressure loss is 85.3 Pa/m, specific consumption of electric power to transport the heat carrier is 0.81 W/m, specific heat loss is 33.8 W/m
Authors and Affiliations
I. O. Redko, А. O. Redko, A. Pryimak, O. F. Redko
Keywords
Related Articles
- EP ID EP556035
- DOI -
- Views 67
- Downloads 0
An Analytical Description of the Expansion of Plane Wall Jets
The effectiveness of forming microclimate of buildings and structures depends on the decisions of air exchange organization. One of the influencing factors of the efficiency of air exchange organization is the developmen...
Mathematical Model and Method for Calculating the Dynamics of Drying Biomass at the Production of Pellets
All types of biomass (straw, stalks of corn, sunflower, wood shavings, energy willow, sorghum, miscantus) are colloidal capillary-porous bodies, drying of which is carried out in a high-temperature drying agent and invol...
Calculating the Efficiency of Solar Radiation Energy Usage in the Heating Systems Based on the Transformation of the Integrated Energy in Typical Low-Temperature Energy Sources
The possibility to increase the effectiveness of the solar radiation energy usage up to 30^40 percent was established. This result was achieved by heating the energy source with increased flow rate during the expanding o...
Determination of Technical and Economic Indicators of Energy Efficient External Frame-Sheathing Walls Using AQUAPANEL®OUTDOOR Plates
When designing external fencing constructions for buildings of various purposes (industrial, residential and public), both thermal and technical characteristics of structures and technical and economic indicators (TEP) p...
Investigation of Single-Phase Non-Isothermal Filtration in the Geothermal Circulation Systems
In this article, there are geometric model of geothermal porous layer, basic assumptions that accept computational similar systems and thermophysical model of motion and heat transfer of fluids in porous solids. The geom...