Optimization of the soldering process by the DMAIC methodology
Journal Title: Production Engineering Archives - Year 2016, Vol 0, Issue 2
Abstract
The chapter presents the use of the DMAIC method for the analysis and improvement of the process of soldering pins in a plug connecting a bundle of wires to the board of a controller; a part of the steering system of a car. The main problem in the soldering process, that is an unsatisfactory share of bad soldered connections between the board and the plug and the instability of that number, was identified by means of a five-phase improvement process. Key points and main causes of the defect were pointed out, and process improvement meas-ures were suggested. Due to the analysis conducted and the correct implementation of improvement measures the share of defective connec-tions has been decreased twofold.
Authors and Affiliations
Michał Zasadzień
Keywords
Related Articles
- EP ID EP261146
- DOI -
- Views 69
- Downloads 0
Recycling and segregation of used aluminium beverage cans according to the residents of Silesia voivodship
Aluminium is one of raw materials that can be practically continuously recycled. Thanks to the proper sorting of aluminium scrap it is possible to produce precisely the same products that it was made before Selective was...
Automatization in road transport: a review
In this article automatization of road transport is investigated. In the first chapter relevant international trends were identified. In this paper the research hypothesis is that in the case of automatized road vehicle...
Quality analysis of plates for car industry
In 2013, global steel production reached a level of 1.548 million tons. This value indicates that, in the 21st century, steel is still one of the most popular construction materials. In Poland 8.2 million tons of steel w...
The issue of wooden and concrete railway sleepers utilization
The high degree of degradation of the surface of the existing rail road causes the intensification of the modernization works. Due to modernization of the railway track, damaged parts of trackway are replaced with new on...
Context of production engineering in management model of Value Stream Flow according to manufacturing indus-try
The popularity of visual management in the lean concept is caused by the possibility to apply it in solving different kind of issues related to reduce waste or process planning. The adaptations of VSM is focused on strea...