Optimization of Welding Modes for High-Strength Low-Alloy Domex 700 Steel
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2017, Vol 3, Issue 2
Abstract
The microstructure and hardness of the weld joints of DOMEX 700 steel were investigated. As a result, the optimization of the parameters of robotic arc welding in the environment of protective gases was carried out taking into account the size of the energy per unit length. The optimum modes of welding were determined. The size of the deterioration area, where there is a decrease in hardness in comparison with the main metal, for a thickness of 6 mm is 2.36 mm, and for a thickness of 3 mm is 1.51 mm. The parameters of the robotic welding process in the arc mode in the environment of protective gases for the investigated thicknesses of the DOMEX 700 steel were recommended. As a result, the energy-saving conditions for welding performing were achieved ensuring the required technological strength.
Authors and Affiliations
Andrii Dzyubyk, Volodymyr Palash, Ivan Khomych, Stanislav Hrynus
Keywords
Related Articles
- EP ID EP281280
- DOI 10.23939/ujmems2017.02.047
- Views 105
- Downloads 0
Structure and wear resistance of aluminium alloys coated with surface layer laser-modified by silicon carbide
Modern approaches to ensuring the necessary characteristics of surface of a material with the aim to improve economic and technological characteristics of the structures are considered in this paper. It is shown that alu...
Structural and Kinematic Synthesis of the 1-DOF Eight-Bar Walking Mechanism with Revolute Kinematic Pairs
Problem statement. The use of existing and the most widespread drives (wheeled and caterpillar one) is sometimes limited by complicated operational conditions while moving on rough terrain. The mentioned drives require a...
Asymptotic method in investigation of complex nonlinear oscillations of elastic bodies
The main provisions of the methodology of the study of complex oscillations of elastic bodies are outlined. Its main idea is as follows: a) on the basis of empirical studies, the change of the basic parameters of some fo...
The Influence of Chemical-Thermal Treatment on Granulometric Characteristics of Titanium Sponge Powder
The phase composition and structure of powders of titanium sponge exposed to processes of chemical and thermal processing is investigated. As a result of X-ray analysis, it is found that after hydrogenation titanium powd...
Optimal gear shift algorithm in the car transmission during its deceleration
On the way to improving the car one can not avoid the problem of optimal gear shift in stage transmissions. Typically, the gear (stage) shift laws are distinguished, which are optimal because of fuel efficiency, either i...