Origin and Characterization of Joints in Sedimentary Rocks: A Review
Journal Title: Petroleum & Petrochemical Engineering Journal - Year 2018, Vol 2, Issue 5
Abstract
Discontinuities are ubiquitous in all rocks at different scales. Their characterization occupies a high ground in the field of geological research. Discontinuity abundance, strength, flow and frictional properties are matters of great interest to structural geologists, petroleum engineers (mostly in unconventional shale gas and oil production) and civil engineers. Joints (opening mode fractures) are some of the most commonly observed rock discontinuities among others. Understanding joint origins from outcrops and other directly visible sources explain the presence of certain joints in the near and deep subsurface. We have summarized several tectonic and non-tectonic drivers behind joint origins and suggested the use of multiple supporting evidence while timing and causal interpretations are made. If particular subsurface joint sets may be traced back to the outcrops through the knowledge of their origins, the characteristics (length, aperture, height, abundance and interrelationships between these parameters) of the particular near or deep subsurface joint sets may be measured at the outcrops or the other data sources such as cores and image logs. Additionally, it is important to understand several non-visual data sources aiding in joint parameterization. This paper discusses the strengths and limitations of these direct (visual) and indirect (inference) data sources. In addition, we have summarized different methods for the quantification of the aforementioned joint related geometric and abundance parameters. We have shown that each measurement method and data source has its own set of strengths and limitations, and the appropriate methods to be used are case specific. We suggest that, if possible, characterization by direct visualization (mainly outcrops) should not be withheld or substituted with techniques that only imply the presence of joints and faults. Also, reconciliation of all joint-related parameters (i.e., geometry and abundance) from all available data sources provide confidence in the geologic interpretation and models.
Authors and Affiliations
Sayantan Ghosh
Keywords
Related Articles
- EP ID EP597296
- DOI -
- Views 63
- Downloads 0
Comparative Analysis of Barite and Hematite Used in WaterBased Drilling Fluid
To meet the future demands and tackling the challenges, the O&G industry needs more than just going for discovering the unproven hydrocarbon reserves. Technologies way beyond the available ones requires tremendous develo...
Prediction of the Rise velocity of Taylor Bubble in Vertical Tube
A single gas bubble moving under the influence of gravitational, inertial, viscous and interfacial forces, relative to another fluid contained in a vertical cylindrical tube. Two-phase flows through millimeter channels m...
Recent Advances in Proppant Embedment and Fracture Conductivity after Hydraulic Fracturing
Studies on fracture conductivity and proppant distribution in fractures are frequently carried out with growing attention drew to stable production and maximizing conductivity. Laboratory inability to create formation co...
Air-Water Two-Phase Flow through Small Diameter Pipes
In this study, the flow patterns of air - water, two-phase flows have been investigated experimentally in a vertical and horizontal milli channel. The flow regimes were observed by a high speed video recorder in pipes wi...
Spatio-Temporal Variations of Heavy Metals in Edible Crabs Collected From the Lower Gangetic Delta Region
We studied the concentrations of heavy metals (Zn, Cu and Pb) in the edible crabs collected from four different stations in the lower Gangetic delta for a period of more than one decade. Same heavy metals were also monit...