Parameters monitoring and control for flueric actuators testing system
Journal Title: INCAS BULLETIN - Year 2014, Vol 6, Issue 1
Abstract
A wide range of air supply parameters is needed for the flueric actuators testing in order to find their optimum working regime. A system for conditioning these parameters, namely pressure, temperature, mass and volume flow rate has been built for this purpose. The measured values are continuously stored on the PC hard drive and are checked automatically for keeping them in the normal operating range. In case any of them are going out of this range, this system warns the operator and performs automatic actions for limiting or partially or totally shutting down the system.
Authors and Affiliations
SALAORU Tiberiu Adrian, ANDREI Marina, ION GUTA Dragos Daniel , ARGHIR Minodor
Keywords
Related Articles
- EP ID EP88355
- DOI 10.13111/2066-8201.2014.6.S1.15
- Views 138
- Downloads 0
STUDIES ON FLUTTER PREDICTION
The purpose of this paper is to study the instability of the dynamic flutter. The justification is expressed by the fact that the occurrence of flutter within the aircraft’s flight envelope results in irreversible struct...
Comment on the volume: RESEARCH TRENDS IN MECHANICS, Vol. 4 Editors: Ligia MUNTEANU, Veturia CHIROIU, Tudor SIRETEANU Editura Academiei Române, Bucureşti, 2010
A Brief Discussion Regarding Types of Cavitation in Squeeze Film Dampers and Cavitation Effects
Squeeze film dampers (SFD) are probably the most used shaft control devices in aircraft jet engines; SFDs consist in oil films, elastic elements and various antirotational devices that tune the stiffness and damping of t...
Aerodynamic performance prediction of Darrieus-type wind turbines
The prediction of Darrieus wind turbine aerodynamic performances provides the necessary design and operational data base related to the wind potential. In this sense it provides the type of turbine suitable to the area w...
Strain measurements using Fiber Bragg Grating sensors in Structural Health Monitoring
The paper presents some results obtained within a project of the “NUCLEU” Program financed by the Ministry of Research and Innovation-ANCS. The project supposes, among others, the design and the realization of a demonstr...