Penetration Tests of Armour Plates Made in New Technologies
Journal Title: Problemy Mechatroniki. Uzbrojenie, lotnictwo, inżynieria bezpieczeństwa - Year 2011, Vol 2, Issue 3
Abstract
This paper presents the results of the tests of experimental armour resistance for penetration with 7,62x54R mm Mosin and 12,7x99 mm NATO round. The highest ballistic resistance to the impact of a 7,62 mm-calibre bullet (level III according STANAG) was observed for plates that were pad welded with a P-CNi-AlNiAl layer. Whereas, for a 12,7 mm-calibre bullet, the best results were obtained for nanostructural padding welds. Tests were made by the Faculty of Mechatronics, Military University of Technology, during the R+D project PBR/15-022/2009/WAT entitled: „HVOF arc and flame spraying as GMA and laser pad welding of nanostructural composite and gradient surface layers that are characterised by a high ballistic resistance of an armour’s protection module”
Authors and Affiliations
Zdzisław BOGDANOWICZ, Jacek BOŻEJKO, Andrzej KLIMPEL, Wojciech KOPERSKI, Zbigniew SURMA, Łukasz SZMIT, Ryszard WOŹNIAK
Keywords
Related Articles
- EP ID EP62880
- DOI -
- Views 68
- Downloads 0
State of the Art Technologies Used as a Rescue Response During Recovery from Structural Collapse
This paper is a description of the state of the art technical equipment procured during the execution of the project ‟Innovative solutions for stabilizing building and engineering structures as a rescue response during s...
Przenośny System do Przechwytywania Miniaturowych Bezzałogowych Statków Powietrznych (PSP-MBSP)
W pracy przedstawiono zakres i stan obecny realizowanego w Instytucie Techniki Uzbrojenia (ITU) Wydziału Mechatroniki i Lotnictwa (WML) Wojskowej Akademii Technicznej (WAT) projektu DOB-1P/02/18/2016, finansowanego przez...
The Dependence of the Launch Zone on the Characteristics of the Controlling Gas-Dynamic Force
The aim of the paper is to present how the controlling characteristics of the small gas-dynamic engine affect the scope of the missile launch zone. The short-range self-targeting missile model was applied in the numerica...
Characterization of Al Based Coatings Deposited by PVD Technique onto Samples Made from High Speed Steel
The paper deals with evaluation of selected properties of TiAlN and CrAlN coatings deposited by PVD technique on specimens from the high speed steel HS6-5-2-5 (STN 19 852). There were evaluated tribological properties su...
Boundary Conditions of Main Problem of Intermediate Ballistics
In the paper, experimental observations concerning phenomena of the intermediate ballistics are discussed. Basing on these observations, a physical model of the phenomena have been proposed and the main problem of the in...