Perancangan Jaringan Indoor 4G LTE 1800 MHz Gedung Elektronika Politeknik Negeri Balikpapan Menggunakan Radiowave Propagation Simulator 5.4
Journal Title: Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) - Year 2019, Vol 6, Issue 1
Abstract
Indoor area is an area that lacks a signal so that the signal attenuation continues to be problems that often occur. To overcome these problems need the support of a communication system that can include a signal in the room so that customers can keep communicate with smoothly. The need for application of indoor mobile communications system to support the outdoor system that can serve the entire mobile service users. This research discusses the planning of indoor femtocell LTE 4G network at the electronics building of the Balikpapan State Polytechnic is on the floor 1,2 and 3 with models Cost 231 multiwall indoor propagation. This design is simulated using 5.4 Software Radiowave Propagation Simulator (RPS). From the calculation results, the number of Femtocell Access Points (FAP) on each floor is 3, the placement of FAP in the middle part of each floor of the Electronics building. From the design results obtained on the 1st floor RSRP value of -32.18 dBm and SIR of 12.31 dB, for floors 2 RSRP -34.20 dBm and SIR of 13.52 dB, and floor 3 RSRP value of -33.32 dBm and SIR is 13.27 dB
Authors and Affiliations
Maria Ulfah, Nelsia Pither Tadung
Keywords
Related Articles
- EP ID EP549363
- DOI 10.33019/ecotipe.v6i1.950
- Views 60
- Downloads 0
Pengaruh Ketidakseimbangan Beban Terhadap Stabilitas Steady State
The stability of the electric power system is related to the balance of power in the system. When a power change occurs, the rotor will swing affecting the power angle, rotation speed, frequency and stability of the syst...
Sistem Informasi Objek Wisata Jelitik Kabupaten Bangka Berbasis Webserver
Bangka has a beautiful tourist destination and attract tourists to visit, especially coastal tourism. One of them is a tourist destination in the village of Jelitik with beautiful and interesting beach tourism potential...
Disain Pengendali Slip pada Haul Truck Mengunakan Metode Sliding Mode Controller
Changes in road conditions and friction wheel slip can result in the vehicle causing inconvenience to the user of the vehicle. To overcome this it is necessary to control the vehicle to slip in a state of minimal slip. I...
Analisa Pengendali Hybrid Sliding Mode Control dan Fuzzy Logic Controller dalam Penurunan Error Steady State Untuk Mengendalikan Concentration pada Isothermal Continuous Stirred Tank Reactor (CSTR)
Systems in industry often occur in performance or desired performance. One of them isothermal CSTR system where the system has not been able to work according to the desired set point 1 g.mol / litter, to achieve the set...
Rancang Bangun Unipolar PWM untuk Pengendalian Rangkaian H-Bridge Menggunakan Operational Amplifier
Unipolar PWM control technique carried out by comparing triangular wave with two control voltages. The resulting pulses are used to control H-Bridge circuit. The technique can be done by using the functions of the operat...