Physical Characteristics of Grout for Low Density Roads

Journal Title: Saudi Journal of Civil Engineering - Year 2017, Vol 1, Issue 1

Abstract

Abstract:The presented study represents the results of an experimental study handled with developed grouting materials. These experimental studies cover the effects of some mineral Admixtures and chemical admixtures on the characteristics of grout such as compressive strength, bleeding, setting time and viscosity for different curing times. All grout types were prepared under same water/cement ratio. Grout mixtures that 15% of mineral admixtures replaced with cement by weight were prepared. The results showed that grouts produced with silica fume (SF) and metakaolin (MK) in all mixtures were yielded the highest compressive strength at all ages. The all strength tests of fly ash (FA) grout exhibited low values till 28 days of curing time in accordance with reference grout, but a sharp increase was observed after this period. Grouts with perlite (PRL) and blast furnace slag (BFS) showed the similar strength values according to reference grout. Mineral admixtures can be used for high-strength and low cost grout in tunneling applications. In addition, the use of waste materials can contribute to the resolution of environmental problems. Compressive strength obtained by the grout prepared by using styrene butadiene rubber was found 23.644 N/mm2 and 34.793 N/mm2 for 7 and 14 of curing period where compressive strength obtained by the grout prepared by using fly ash was found 20.444 N/mm2 and 31.827 N/mm2 for 7 and 14 days of curing period. Keywords:Grout, Compressive strength, admixtures, cement and mix design

Authors and Affiliations

Poonam Mahajan, Shrikant M. Harle

Keywords

Related Articles

Land use Land Cover Change Detection for Doon Valley using Arc-GIS & ERDAS Tool

Abstract:The land use change has generally occurred locally, regionally and world wide over the last few decades and will carry on in the future as well the land use change has to be evaluated properly using conventional...

Influence of Gravel Beds on Erosion of Sand by Submerged Jets

Abstract: This paper shows experimentally effect of gravel beds to reduce erosion of soil downstream of submerged hydraulic jumps by using a physical model, gravel beds are employed downstream of radial gate to dissipate...

Effective Project Preparation Process: A Key Factor to a Successful PPP Infrastructure Development

Abstract:Management of PPP project preparation process according to WEF (2013) is quite complex because it involves large team and multiple stakeholders such as ministries, regulatory organs and regulations, engineering...

Physical Characteristics of Grout for Low Density Roads

Abstract:The presented study represents the results of an experimental study handled with developed grouting materials. These experimental studies cover the effects of some mineral Admixtures and chemical admixtures on t...

Testing on Cores from Concrete Roads

Abstract:This study presents the information and conclusions about numerous tests – destructive and non-destructive – on concrete core specimens. The main focus is made on basic tests namely density test, water absorptio...

Download PDF file
  • EP ID EP401644
  • DOI -
  • Views 73
  • Downloads 0

How To Cite

Poonam Mahajan, Shrikant M. Harle (2017). Physical Characteristics of Grout for Low Density Roads. Saudi Journal of Civil Engineering, 1(1), 37-44. https://europub.co.uk./articles/-A-401644