QUALITY OF WELD CLADS APPLIED BY SAW METHOD IN ADHESIVE WEAR CONDITIONS
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2013, Vol 20, Issue 1
Abstract
This contribution deals with the analysis of the renovation layer quality of continuous casting steel rolls, developed through the submerged arc surfacing method (SAW). The continuous casting roll was analysed via the degradation phenomena which act during the operation. Four kinds of filler materials were used for the renovation of the worn roll. Surfacing was carried out as a three-layer in order to eliminate the need for intermediate layer formation. The quality of weld deposits was evaluated in terms of the structure, hardness and wear resistance of weld deposits at 23°C and 400 °C using pin-on-disc wear test. The best properties showed newly developed filler material W8-WLDC8 from the point of view of the hardness, together with wear resistance of the deposited layers in room and elevated temperatures.
Authors and Affiliations
Janette Brezinová, Anna Guzanová, Peter Balog
Keywords
Related Articles
- EP ID EP161333
- DOI -
- Views 112
- Downloads 0
Degradation of Czechoslovak creep resistant steels after 50 years of service
Thermally loaded assemblies in the energy and chemical industries require materials that provide the necessary functional characteristics, even after very long periods of operation. For the assessment of these materials...
Static and dynamic tensile characteristics of DP600 steel sheets
Dynamic tensile testing of sheet steels is becoming more important. Experimental dynamic tensile technique is depending on the strain rate. Each serves for a specific range of strain rates and provides specific type of i...
SOLUTION TREATMENT EFFECT ON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF AUTOMOTIVE CAST ALLOY
The contribution describes influence of the heat treatment (solution treatment at temperature 545°C and 565°C with different holding time 2, 4, 8, 16 and 32 hours; than water quenching at 40°C and natural aging at room t...
EFFECTIVNESS OF THE FATIGUE CRITERIA FOR COMBINED BENDING – TORSION LOADING
Most of mechanical components in the engineering are frequently subjected to combined loading, which can lead to sudden fatigue failure. In present work the fatigue life of plasma-nitrided and virgin specimens is studied...
SELF-LUBRICATING THIN FILMS FOR TOOL STEELS
Specimens made from Vanadis 6 cold work tool steel were machined, ground, heat processed by standard regime and finally mirror polished. After that, they were layered with CrAgN. The Ag-content in the layers was chosen t...