Reactive Power Improvement Using STATCOM in Wind Park Energy System
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 4
Abstract
Large number of wind turbines are being installed and connected to power systems. In some of the countries the penetration of wind power is significant high so as to affect the power quality, system operation and control and power system stability. In this paper an attempt is made to predict the reactive power burden of the wind farm based on conventional fixed speed induction generator during wind variation and fault condition. MATLAB based large scale wind farm model is developed where STATCOM is introduced as an active voltage and reactive power supporter to increase the power system stability. STATCOM unit injects reactive power to mitigate power quality problems and to get stable grid operation.
Authors and Affiliations
M. Anbarasi, K. Pandia Rajan, K. Karthikeyan
Keywords
Related Articles
- EP ID EP20054
- DOI -
- Views 276
- Downloads 4
Efficient Fuzzy Traffic Adaptation Solution in Wireless Mesh Networks
As wireless communication gains more advancement, significant research has been developed and adapted to support real time transmission which strengthens quality of services. Requirement for wireless communication and...
slugTime Synchronous Adaptive Rollback Recovery Protocol for Mobile Distributed Systems
Time can play a important role for determining consistent global state in mobile computing environment in a minimum cost as it does not requires extra coordination message and thus, avoids most causes of o...
Computational Analysis of a Centrifugal Compressor with Partial Shroud
Computational analysis of low speed centrifugal compressor is carried out by inexpensive partial shroud near the rotor blade tip with finite volume method using ANSYS-CFX software. Centrifugal compressor impeller with t...
Operating System Challenges for GPU Resource Management
The graphics processing units(GPU) have rapidly evolved to become high performance accelerators for dataparallel computing. For accelerating graphics and data-parallel compute-intensive applications the GPU is a most pop...
Implementation of 8-bit Sigma-Delta ADC using 45nm Technology
Design for oversampling sigma-delta (ΣΔ) ADCs is conferred here. In this paper a contemporary design for 8-bit ΣΔ oversampling ADC is presented, in which first order oversampling ΣΔ modulator and the decimation filter i...